Asus AAEON ZEUS-WHI0 User Manual page 49

Options Summary
Data bit
Data Bits
Parity
A Parity bit can be sent with the data bits to detect some transmission errors.
Even: parity bit is 0 if the num of 1's in the data bits is even.
Odd: parity bit is 0 if the num of 1's in the data bits is odd.
Mark: parity bit is always 1.
Space: Parity bit is always 0
Mark and Space Parity do not allow for error detection. They can be used as an
additional data bit.
Stop Bits
Stop bits indicate the end of a serial data packet. (A start bit indicates the beginning).
The standard setting is 1 stop bit. Communication with slow devices may.
Flow control
Flow control can prevent data loss from buffer overflow. When sending data, if the
receiving buffers are full, a 'stop' signal can be sent to stop the data flow. Once the
buffers are empty, a 'start' signal can be sent to re-start the flow. Hardware flow control
uses two wires to send start/stop signals.
VT-UTF8 Combo Key
Support
Enable VT-UTF8 Combination Key Support for ANSI/VT100 terminals.
Recorder Mode
With this mode enabled only text will be sent. This is to capture Terminal data.
Resolution 100x31
Enables or disables extended terminal resolution.
Putty KeyPad
Chapter 3 – AMI BIOS Setup
7
8
None
Even
Odd
Mark
Space
1
2
None
Hardware RTS/CTS
Enabled
Disabled
Disabled
Enabled
Disabled
Enabled
VT100
LINUX
XTERMR6
SCO
ESCN
VT400
Optimal Default, Failsafe Default
Optimal Default, Failsafe Default
Optimal Default, Failsafe Default
Optimal Default, Failsafe Default
Optimal Default, Failsafe Default
Optimal Default, Failsafe Default
Optimal Default, Failsafe Default
Optimal Default, Failsafe Default
36