Related Manuals for Dell P2419H
Summary of Contents for Dell P2419H
- Page 1 P2419H 1. Disassembly Procedures: Step Figure Remark Turn off power, S1.Before Unplug external disassemble cablesfrom product Press the button on the red then pull out the S2. Remove the stand upward, stand stand will be remove.
- Page 2 P2419H Use a Philips-head screwdriver to remove 4 screws for unlocking mechanisms. (No.1~4 screw size=M4x10; Torque=12±2kgf.cm） S3.Remove the REAR COVER. Use Penknife to separate the bezel and rear cove follow the arrows in sequence, then you can take out rear cover.
- Page 3 P2419H Use a Philips-head screwdriver to remove 11 screws for unlocking S5.Remove the middle frame. Middle_Frame (No.1~11 screw size=M3x3; Torque=3±0.5kgf.cm） 1. Use a Philips-head screwdriver to remove 4 screws for unlocking S6.Remove the main frame. (No.1~4 screw Main frame and the pin size=M3x3;...
- Page 4 P2419H S7.The Panel Use a Philips-head screwdriver to remove 3 screws for unlocking the Deco bezel (No.1~3 screw size=M2x2.5; Torque=0.9±0.4kgf.cm) S8.The Middle frame、The Deco Bezel and the Key Board...
- Page 5 P2419H Use a Philips-head screwdriver to remove 3 screws for unlocking Main board. (No.1~3 screw size=D3x6 Torque=6±1kgf.cm) S9.Remove the Main Board Use a hex screwdriver to remove 2 screws for unlocking mainboard （No.1~2 Hex screw Torque= 4.5± 0.5kgf.cm) S10.Disconnect Disconnect the pins...
- Page 6 P2419H 1.Take off the Mylar 2. Use a Philips-head screwdriver to remove 3 screws for unlocking the Power Board S11.Remove the Mylar and the (No.1~2 screw Power Board size=D3x6 Torque=6±1kgf.cm No.3 screw size=M4x6 Torque=6±1kgf.cm) S12.The Mainframe Use a Philips-head screwdriver to remove S13.Remove the...
- Page 7 P2419H Remove electrolyte capacitors (red mark) from printed circuit boards S15.Remove capacitors Take out bulk cap. pin solder with soldering iron and absorber...
- Page 8 P2419H Lift the bulk cap. up and away from the PCB...
-
Page 9: Tools Required
P2419H 2. Product material information The following substances, preparations, or components should be disposed of or recovered separately from other WEEE in compliance with Article 4 of EU Council Directive 75/442/EEC. Capacitors / condensers (containing No used PCB/PCT) Mercury containing components...