Table of Contents
Advertisement
Initial Setup
Auto Tuner Setup
The auto tuner setup function is described on page 22 as the interactive plug-in menu. If you
need to run the auto tuner setup again, follow the steps below.
Press the M
π †
To AUTO TUNER SETUP
è
To operate
è
To choose CABLE or AIR
Press the O
Programming will take approximately 1 to 2 minutes. The auto tuner is finished when the
message PROGRAMMING OVER! appears onscreen.
Press the Menu button when finished
Channel Summary
Channel summary allows you to customize the line-up of channels received by your TV. You
can add or delete channels from the line-up or prevent any unauthorized viewers from watching
any or all 181 channels.
Press the M
π †
To CHANNEL SUMMARY
è
To operate
The Channel summary screen will now be displayed with
the channels set to scan marked with an "√". You can delete
channels from the scan by removing the "√". If any channels
were missed during auto tuner setup and you wish to add
them, you may by placing an "√" next to the channel number.
è
π †
To the SCAN column
Press the O
Press the M
You can block access to a channel by activating the channel lock.
Press the M
π †
To CHANNEL SUMMARY
è
To operate
è
π †
To the Lock Column (
Press the Z
Press the M
30
button
ENU
button to start
K
button
ENU
button to include or delete from scan
K
button when finished
ENU
button
ENU
)
button to lock or unlock that channel
ERO
button when finished
ENU
Advertisement
Table of Contents
