Cleaning And Maintenace; Disposal - Energizer EZMO160-210 User Manual

Mini multifunctiontool
Table of Contents

Advertisement

To switch on, push the ON/OFF switch to "I" position.
To switch off, push the ON/OFF button to the "0" position.
8. CLEANING AND MAINTENANCE
8.1 MAINTENANCE
Always disconnect the device before performing any adjustment or maintenance operation.
Disconnect from the power supply immediately if the supply cord is damaged.
Take care not to expose this tool to the rain.
If the carbon brushes need to be replaced, have this done by a qualified repair person (always
replace the two brushes at the same time).
Regularly inspect the accessory, ensure the accessories are free of crack and surface defects.
Replace the accessory when it has worn out.
If the supply cord of this power tool is damaged, it must be replaced by a specially prepared cord
available through the service organization
8.2 CLEANING
This tool does not require any special maintenance. Regularly clean the ventilation slots. Avoid
using solvents when cleaning plastic parts. Most plastic parts are susceptible to damage from
various types of commercial solvents and may be damaged by their use. Use clean cloths to
remove dirt, carbon dust, etc.
8.3 LUBRICATION
All the bearings in this tool are lubricated with a sufficient amount of high grade lubricant for the life
of the unit under normal operating conditions; therefore no further lubrication is required.
8.4 STORAGE
Place the tool and all the accessories on the box. The box shall be stored in a dry place, out of
reach of
children.

9. DISPOSAL

Electric power tools, as well as their accessories and packaging, must each be able to
follow an appropriate recycling pathway. Only for the countries of the European Union:
Do not throw away your electrical appliance with the household waste! In accordance with
the European Directive 2012/19/EU on waste electrical and electronic equipment and its
implementation in national laws, power tools that can no longer be used must be
separated and follow an appropriate recycling pathway.
HSS cutters
Drill bits
Brush
L pin
9000~35000
4500~35000
4000~15000
N/A
16
6
6
2

Advertisement

Table of Contents
loading

Table of Contents