Table of Contents
Advertisement
Problem
Water flows on the floor.
Temperature cannot be set.
The temperature in the appliance is
too low/too high.
If the advice does not lead to the desired
result, call the nearest Authorized
Service Centre.
8.2 Closing the door
1. Clean the door gaskets.
16
ENGLISH
Possible cause
The water outlet is clogged.
The melting water outlet is not con‐
nected to the evaporative tray above
the compressor.
The Super Freeze function is
switched on.
The temperature is not set correctly. Set a higher/lower temperature.
The door is not closed correctly.
The food products' temperature is
too high.
Many food products are stored at
the same time.
The thickness of the frost is greater
than 4-5 mm.
The door has been opened often.
The Super Freeze function is
switched on.
There is no cold air circulation in the
appliance.
2. If necessary, adjust the door. Refer to the
3. If necessary, replace the defective door
Solution
Clean the water outlet.
Attach the melting water outlet to
the evaporative tray.
Switch off the Super Freeze function
manually, or wait until the function
deactivates automatically to set the
temperature. Refer to the "Super
Freeze function" section.
Refer to the "Closing the door" sec‐
tion.
Let the food products temperature
decrease to room temperature be‐
fore storage.
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessary.
Refer to the "Super Freeze function"
section.
Make sure that there is cold air cir‐
culation in the appliance. Refer to
the "Hints and tips" chapter.
"Installation" chapter.
gaskets. Contact the Authorised Service
Centre.
Advertisement
Table of Contents
