Related Manuals for Lorentz PS Commander
Summary of Contents for Lorentz PS Commander
- Page 1 PS Commander Monitoring and managing systems remotely Manual for Installation and Operation The Solar Water Pumping Company...
-
Page 2: Table Of Contents
Placement of the PS Commander....... .8 Subscribe to the LORENTZ Global service which Start-up and operation .. -
Page 3: Product Features
ƒ 19-001860/19-001870: 2G/4G (LTE-M1 or in a closed and dry room. The PS Commander can be governments. LTE-NB) stored in the range of -4 °F to 122 °F (–20 °C to 50 °C). -
Page 4: Wiring
PV-Module characteristics 4.2.1 Battery 4.2.3 Fuse If a battery is not delivered by LORENTZ, it must Use the 2 pin battery plug with the pre-assembled The fuse is switched in the red cable (plus) of the meet the following characteristics: cables. -
Page 5: Placement Of The Ps Commander
Place the PV-Module holder at least 10cm (3.95 in) the Commander. installation, battery installation and an established above the PS Commander. The holes in the wall, for ƒ connect to the best network available pump connection before finally mounting the PS the PV module holder, have to be 330mm (13.0 in) -
Page 6: No Connection To Telecommunication Network
ƒ the antenna cable is not broken 6.5 SIM card ƒ the antenna cable is screwed tightly to the The PS commander will try to find a network until it Figure 3: Insert SIM card terminal is connected. If it does not find a network there is a risk of emptying the battery. - Page 7 Sun. Water. Life. www.lorentz.de...
Need help?
Do you have a question about the PS Commander and is the answer not in the manual?
Questions and answers