Sharp SJ-P682MFG-K Operation Manual page 17

Problem
The food in SJ-PG51P2,
the refrigerator
SJ-PG55P2,
compartment are
SJ-PG60P2,
frozen.
SJ-FTG18CVP,
SJ-FTG21CVP,
SJ-P682MFG,
SJ-P782MFG,
SJ-P882MFG
SJ-PS51P,
SJ-PS55P,
SJ-PS60P,
SJ-P601MFM,
SJ-P701MFM,
SJ-P801MFM
Odors in the compartment.
The control panel does not work.
(Only for SJ-PG51P2, SJ-PG55P2,
SJ-PG60P2, SJ-FTG18CVP,
SJ-FTG21CVP, SJ-P682MFG,
SJ-P782MFG, SJ-P882MFG)
Some lines are on the surface of
the plastic parts.
Door alarm does not stop.
(Only for SJ-PS51P, SJ-PS55P,
SJ-PS60P, SJ-P682MFM,
SJ-P782MFM, SJ-P882MFM)
If you still require service
Refer to your nearest service agent approved by SHARP.
• Is the refrigerator operated for a long time with refrigerator temperature
control set at 0°C?
-- Change the temperature control back to around 3°C.
• Is the refrigerator operated for a long time with freezer temperature control
set at -21°C?
-- Change the temperature control back to around -18°C.
• If ambient temperature is low, foods may freeze even if the refrigerator
compartment is set at 6°C.
• Is the refrigerator operated for a long time with refrigerator temperature
control set MAX COLDEST?
-- Change the temperature control to the other setting.
• Is the refrigerator operated for a long time with freezer temperature control
set MAX COLDEST?
-- Change the temperature control to the other setting.
• If ambient temperature is low, food may freeze even if the refrigerator
compartment is set MIN.
• Wrapping is required for the food with strong odors.
• Deodorizing unit cannot remove all odors.
• Clean the inside periodically.
This may occur in one of the following cases.
• The panel or your fi nger is soiled with dripping, oil and etc.
• When you touch the panel with gloved hand, adhesive bandage on your
fi nger,nail or objects.
• Sticker or tape is affi xed on the keys.
• Touch position is slightly off from the keys.
• Operate time is not enough for the keys to work.
• These are not defects during production.
The meeting part of the resin material or
the junction part of the metallic mold are
remained like lines.
If the door alarm does not stop after closing all doors, it is a defect. Contact
the SHARP service center for service.
Method of stopping the door alarm temporarily
Press "R" button and "F" button simultaneously
and continuously for 3 seconds or more.
• The door alarm will sound again after
approximately 2 days.
Solution
Line
Beep beep beep
16