Subscribe to Our Youtube Channel
Related Manuals for Ctl VoiceSupport Lx
Summary of Contents for Ctl VoiceSupport Lx
- Page 1 VoiceSupport LX Linux Based Voice Mail System Adding D/4PCIUF Port Cards August 2006...
- Page 2 No representation is made that this guide is complete or accurate in all respects, and CTL Corporation shall not be liable for any errors or omissions. In no event shall CTL Corporation be...
-
Page 3: Table Of Contents
Configuring the System ........................8 To configure the number of ports..................... 8 To view and customize Port Options ....................9 Backing Up the Feature Files ......................11 To perfrom the Local Backup procedure..................11 VoiceSupport LX - Adding D/4PCIUF Port Cards... - Page 4 Table of Contents VoiceSupport LX - Adding D/4PCIUF Port Cards...
-
Page 5: Introduction
Introduction Introduction This document provides information for adding D/4PCIUF port expansion cards to an VoiceSupport LX Voice Mail System. Tools and You will need the following tools and materials to install a D/4PCIUF Port Card: Materials D/4PCIUF Port Card Required... -
Page 6: Installing The D/4Pciuf Port Card
The VoiceSupport unit may contain one or more D/4PCIUF cards. You can add port cards until either the maximum number of ports is reached or you have used all the expansion slots. VoiceSupport LX Adding D/4PCIUF Port Cards... -
Page 7: D/4Pciuf Port Card
Set SW1 on the card to: Slot 1 Slot 2 Slot 3 Slot 4 Slot 5 Slot 6 " nd Bracket Numbers on SW1 dial go from: (zero) through 9" dge of Card Bracket 9" D4PCI VoiceSupport LX Adding D/4PCIUF Port Cards... -
Page 8: Removing The Cover
4) Remove and retain the five hex head screws securing the cover. In the figure below, an arrow points to each screw that you need to remove. 5) Remove the cover by sliding it towards the rear of the chassis, and set it aside on a clean surface. VoiceSupport LX Adding D/4PCIUF Port Cards... -
Page 9: Installing The Card
7) Plug the power cord into the surge protector and the AC Power connector at the back of the chassis. 8) Use the Power Switch to turn on the system power. Note - When the Voice Mail unit reboots, the VM Service will automatically restart. VoiceSupport LX Adding D/4PCIUF Port Cards... -
Page 10: Installing The Feature File
3) Call CTL Customer Service. Provide the key code of the Voice Mail unit and the serial number of the port card. You will also be asked to provide an Email address where the Feature File can be sent. -
Page 11: To Add The Port Expansion Feature File To The List
Restart button. To view, download, or delete the Feature File: 1) Click on the icon in the Type column next to the Feature File that you want to view. A dialog box is displayed: VoiceSupport LX Adding D/4PCIUF Port Cards... -
Page 12: Configuring The System
3) Click the Install Ports button. While the ports are loading, a Status of "Busy" is displayed. 4) Wait a few seconds and then click the Update Status button. If the ports have finished loading, the Status will indicate "Idle". VoiceSupport LX Adding D/4PCIUF Port Cards... -
Page 13: To View And Customize Port Options
200 to 600, enter 700 in this field. If a second port will have notification enabled, use 701as the extension for that port. Answering Table - The Answering Table that Voice Mail refers to when answering all trunks that use the port. VoiceSupport LX Adding D/4PCIUF Port Cards... - Page 14 Clear Failure - Click the Apply button to clear the fail condition generated after performing an Immediate Self Test. 4) Click the Apply changes button. VoiceSupport LX Adding D/4PCIUF Port Cards...
-
Page 15: Backing Up The Feature Files
4) Click the Backup button. The backup process may take a few seconds depending on the size of the file. If the status is "Busy", wait a few seconds and then click the Update Status button. When the status is "Done", the backup is complete. VoiceSupport LX Adding D/4PCIUF Port Cards... - Page 16 Backing Up the Feature Files VoiceSupport LX Adding D/4PCIUF Port Cards...
Need help?
Do you have a question about the VoiceSupport Lx and is the answer not in the manual?
Questions and answers