Related Manuals for Electric Eel eCAM ACE 2 SL
Summary of Contents for Electric Eel eCAM ACE 2 SL
- Page 1 ACE 2 SL Video Inspection System OPERATOR’S MANUAL For Safe and Effective Operation: Before operation of your system, it is advised that this manual be read carefully.
-
Page 3: Table Of Contents
CONTENTS PAGE 4 LIMITED WARRANTY PAGE 5 LIMITATION OF WARRANTY / SERVICE / FREIGHT PAGE 6 PRODUCT SPECIFICATIONS PAGE 7-8 FEATURE IDENTIFICATION PAGE 9-10 KEYPAD & MENU ICONS PAGE 11 USER INSTRUCTIONS PAGE 12 RECORDING VIDEO / SCREENSHOTS PAGE 13 PLAYING / DELETING FILES PAGE 14 INSPECTION PROCEDURE... -
Page 4: Limited Warranty
Electric Eel's responsibility under this Limited Warranty is limited to the repair, adjustment or replacement of defective parts as determined by Elec- tric Eel in its sole discretion. Electric Eel shall not be held liable for any damages, including but not limited to direct, indirect, special, or conse- quential damages arising out of, resulting from, or in any way connected to the use of Electric Eel products. - Page 5 Elec- tric Eel products. You also agree that the application and use of a Electric Eel product is be- yond our control and is the sole responsibility of the user. By receiving and using one of Electric Eel’s products, you hereby acknowledge and agree...
-
Page 6: Product Specifications
PRODUCT SPECIFICATIONS Weight 45lbs Length x Width x Depth 33" X 19" X 16" Power AC/DC Adapter 12V - 4.1A Battery Only Milwaukee® M18 18V or equivalent Battery Life ~5hrs using 3.0Ah (not recording & sonde off) Battery Extender Yes with on-screen battery display Display Type Impact resistant LCD... -
Page 7: Feature Identification
FEATURE IDENTIFICATION Sunshade and Screen Protector 18V Battery Cradle and AC/ DC Adapter Power Input... - Page 8 FEATURE IDENTIFICATION Keypad 5.5” LCD Screen USB Slot LED Lights Sapphire Camera Window Plastic Skid/Sleeve...
-
Page 9: Keypad & Menu Icons
KEYPAD ICONS Power On/Off Sonde On/Off Menu & Exit Footage Counter Reset Enter / Confirm Selection Navigation Buttons Pause Recording & Stop Recording & Playback Videos Playback Take Screen Record Video MAIN MENU OPTIONS... - Page 10 INFORMATION BAR ICONS Battery Monitor Sonde On/Off & Frequency Footage (ft. or m) Recording Media Date & Time SETTING UP YOUR SYSTEM FOR FIRST USE Your system comes from the factory setup for use using factory de- fault settings. Should you wish to change any functions or options press the MENU key then select Controller Options.
-
Page 11: User Instructions
Turning Your Monitor On Press the POWER button to turn on the controller. At this point you should see the Electric Eel on the screen while the system boots up. Boot up takes ~12 seconds. Note: It is good practice to remove batteries from electronic equipment after use. -
Page 12: Recording Video / Screenshots
RECORDING VIDEO Select the media location you wish to record to in the Controller Menu. You can choose USB, HDD or both USB & HDD. Insert the USB stick into the USB port if you wish to record to USB. All vid- eos are stored in MPEG4 format. - Page 13 PLAYING MEDIA FILES Press the MENU key, then enter the FILE STORAGE OPTIONS menu. Select the date on which files were recorded and then highlight the file you wish to play and press the RIGHT ARROW key on the key- pad or enter key on the keyboard.
-
Page 14: Inspection Procedure
INSPECTION PROCEDURE Skids or sleeves should ALWAYS be used to protect the camera head. De- pending on the size of the pipe you are inspecting, you may need to use a skid, so the camera is centered or off the floor of the line. Care should be taken so the skids do not snag in the line. -
Page 15: Locating The Sonde
LOCATING THE SONDE SIGNAL (512HZ) Insert the sonde in the drain and locate it while it is still just in view at the drain or duct entrance. Hold the locator vertical directly over the sonde with the antenna in line with the sonde. Adjust the locator sensitivity so the bar graph reads between 60% and 80%. -
Page 16: Maintenance
MAINTENANCE Inspection Camera - After every use, the camera should be cleaned and checked for possible damage. External scuffing of the camera case is nor- mal and should be of no concern. The camera view port is made of sapphire and should be cleaned with a soft, damp cloth. - Page 17 REPAIR FACILITIES - USA Repairs, warranty or otherwise, returned to must be submitted with a “Return Maintenance Authorization.” For “RMAs” please contact: Hathorn USA Address: 739 North Wilson Road, Columbus, OH, 43204 Phone: 1-855-863-9226 FAX: 1-905-604-3400 Email: usaservice@hathorncorp.com Website: www.hathorncorp.com Kaiser Premier USA –...
- Page 18 REPAIR FACILITIES - CANADA Repairs, warranty or otherwise, returned must be submitted with a “Return Maintenance Authorization.” For “RMAs” please contact: Hathorn Canada - Ontario, Manitoba & Eastern Canada Address: 255 Shields Court, Unit C, Markham, ON L3R 8V2 Phone: 1-905-604-7040 FAX: 1-905-604-3400 Email: service@hathorncorp.com Website: www.hathorncorp.com Access Spec Telecommunications - Quebec...
- Page 20 Electric Eel Manufacturing Co. Inc 501 West Leffel Lane Springfield, Ohio 45506 1-800-833-1212...
Need help?
Do you have a question about the eCAM ACE 2 SL and is the answer not in the manual?
Questions and answers