Advertisement
4. Lift the Step sections up and over the "cleat" to set them into place as shown in Figure 3.
NOTE:
Each upright and step section is machined with an indexing mark to note where each upright and handrail are
supposed to be installed. A series of 1, 2 or 3 dots on the uprights will match up to the same dots on the outside of the
step section. Attach the uprights so that the dots folds on top of each other as shown in Figure 4.
C
Figure 3: Base with Step sections
5. Attach uprights 'H' on the open ends of the base 'A' using Hex head bolts 'P' and Allen key, with the dots facing inwards
as shown in figure 5. (It may require to remove (2) bolts from the upper mounting positions on the center platform to
attach the uprights or position the step sections). HAND TIGHTEN ONLY!
D
Figure 5: Base with 57 ½" Uprights
6. Attach uprights ('I', 'K' & 'M' respectively) onto the 6-Step section, by matching up the dots on the upright with step
section using six Hex head bolts 'Q' on the bottom of the uprights and two on the top of the 5
Head/Philips screw 'R' with Flat Washer 'U' and Barrel Bolt 'S' on the rest as shown in Figure 6.
7. Attach uprights ('J' & 'L' respectively) onto the 4-Step section using four Hex head bolts 'Q' on the bottom of the
uprights and two on the top of the 3
the rest as shown in Figure 6.
8. Insert the Barrel Bolt 'S' into the straight handrails on the opposite side of the dots as shown in Figure 7.
E
Figure 7: Straight Handrails 'E'
Rev. 102413 aj
Cleat
D
H
C
rd
step, and two Pan Head/Philips screw 'R', Flat washer 'U' and Barrel Bolt 'S' on
S
Dots to match
Figure 4: Dots on Upright & Steps
I
K
M
Q
Figure 6: Base with all Uprights
Figure 8: Straight Handrails attached
Page 2 of 3
J
L
th
step, and four Pan
©2013 HAUSMANN INDUSTRIES, INC.
Advertisement
