Cleaning; Cleaning The Appliance; Cleaning All The Inner Plastic Parts And Door Gasket; Cleaning The Condenser - Bompani BODP740 Installation, Use And Maintenance Instructions

Cleaning - Troubleshooting

CLEANING

Before starting any cleaning, disconnect the
appliance from the mains electricity supply.
The protections (wire grill, covers) must not
be removed by unqualifi ed personnel: do not
use the appliance if the protections have been
removed.
WHEN CLEANING THE INTERNAL PLASTIC PARTS AND
THE DOOR GASKEt:
do not use abrasives or detergents of any kind.
- Use a warm solution of bicarbonate of soda (two
spoonfuls in two litres of water).

CLEANING THE CONDENSER

- This should be carried out at least twice a year.
- Clean using a domestic vacuum cleaner or a brush.
A dirty condenser will have a negative effect on the
appliance and reduce its performance.

FOR PROLONGED ABSENCES

- Empty the compartments.
- Disconnect the appliance from the mains electricity
supply.
- Clean both the compartments and dry them.
- Leave the doors open to prevent bad smells or mould
from forming.
967
1
2
3

CLEANING THE ANTIBACTERIAL FILTER

- Every 4 months.
1 Remove the fi lter-holder cover fi g. 1.
2 Remove the fi lter fi g. 2.
3 Wash it with hot water (it can be washed also in the
dishwasher); dry it at a temperature lower than 100°C;
to maintain a proper fi ltering capacity, replace the fi lter
every 2 years. Remount it in the specifi c seat and place
back the cover fi g1.

CLEANING THE WATER DRAIN

When cleaning the condenser, check that the rear drain
pipe R is not blocked.
- Remove drain pipe R from the container V and if
necessary clean it.
POWER SUPPLY CABLE
- Periodically inspect the power cable to check its
condition.
- If the cable is damaged, do not use the appliance and
do not attempt any repairs. Call a qualifi ed technician
to replace the faulty cable.

TROUBLESHOOTING

1
) THE APPLIANCE DOES NOT WORK.
- Is there a power cut?
- Is the plug inserted properly in the mains socket?
- Is the power supply cable damaged?
- Is the temperature setting correct?.
2) THE TEMPERATURE INSIDE THE COMPARTMENTS IS NOT
LOW ENOUGH.
- Do the doors close properly?
GB
20