Siemens S7-1200 PROFIBUS Operating Instructions Manual page 4

Preface
New in this edition
• New firmware version with the following new functions, among others, compared to the
versions V1.0.4 and V1.0.5:
– Changing the PROFIBUS address from the user program using the data record 8193,
– Small functional improvements
• New approvals (CCC / UKEX)
• Editorial revision
Replaced manual edition
Edition 02/2014
Current manual edition on the Internet
You can find the current version of this manual on the Internet pages of Siemens Industry
Online Support:
Link: (https://support.industry.siemens.com/cs/ww/en/ps/15667/man)
Purpose of the manual
This manual describes the properties of this module and supports you when installing and
commissioning the device.
The necessary configuration steps are described in the form of an overview.
You will find instructions for operation and maintenance and information on the diagnostics
options of the device.
Required experience
To install, commission and operate the CM, you require experience in the following areas:
• Automation engineering
• Setting up the SIMATIC S7-1200 system
• SIMATIC STEP 7
• Data transfer with PROFIBUS
Notes on this document
Product names
• CM / module / device
In this document, these terms are used instead of the complete product designation
CP 1243-1.
4
see:
Link: (https://support.industry.siemens.com/cs/ww/en/view/81522429)
Operating Instructions, 01/2023, C79000-G8976-C245-06
SIMATIC CM 1242-5