ROOMS TO GO KIDS CREEKSIDE 2.0 3954440P Assembly Instructions Manual

ROOMS TO GO KIDS CREEKSIDE 2.0 3954440P Assembly Instructions Manual

Advertisement

CREEKSIDE 2.0 COLLECTION
Read all instructions before assembling bunk bed and keep these instructions for future reference.
-
Before each usage or assembly, inspect bunk bed for damaged hardware, loose joints, missing
-
parts, or sharp edges. DO NOT Use bunk bed if any parts are missing or broken.
DO NOT Use substitute parts. Contact your local Rooms To Go or visit www.ROOMSTOGO.COM
-
for replacement parts and instructional literature if needed.
Follow the information on the warnings appearing on the upper bunk end structure and on the carton,
-
DO NOT REMOVE WARNING LABEL FROM BED.
Always use the recommended size mattress or mattress supports, or both to help prevent the likelihood
-
of entrapment or falls.
-
Ensure thickness of mattress and foundation combine does not exceed
mattress surface is at least
Do not allow children under 6 years of age to use the upper bunk.
-
Periodically check and ensure that the guardrail, ladder, and other components are in their proper
-
position, free from damage, and that all connectors are tight.
Do not allow horseplay on or under the bed and prohibit jumping on the bed.
-
Limit top bunk use to one person.
-
Always use the ladder for entering and leaving the upper bunk.
-
Use of night light may provide added safety precaution for a child using the upper bunk.
-
Always use guardrails on both long sides of the upper bunk. If the bunk bed will be placed next to
-
the wall, the guardrail that runs the full length of the bed should be placed against the wall to
prevent entrapment between the bed and wall.
The use of water or sleep flotation mattress is prohibited.
-
This bunk bed meets all the requirements of ASTM 1427-19.
-
STRANGULATION HAZARD:
Never attach or hang items to any part of the bunk bed that are not designed for
use with the bed; for example, but not limited to, hooks, belts, and jump ropes.
11/7/2022
THANK YOU FOR YOUR PURCHASE

WARNING DANGER

Failure to follow these warnings and assembly instructions could result in serious
injury or death. To help prevent serious or fatal injuries from entrapment or falls:
5 inches (127mm)
10 inches (255mm )
below upper edge of guardrails.
and
Page 1 of 97

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the KIDS CREEKSIDE 2.0 3954440P and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for ROOMS TO GO KIDS CREEKSIDE 2.0 3954440P

  • Page 1 Before each usage or assembly, inspect bunk bed for damaged hardware, loose joints, missing parts, or sharp edges. DO NOT Use bunk bed if any parts are missing or broken. DO NOT Use substitute parts. Contact your local Rooms To Go or visit www.ROOMSTOGO.COM for replacement parts and instructional literature if needed.
  • Page 2 P A R T S L I S T 3954440P FULL/TWIN LOFT W/ 2 CHESTS & 2 BOOKCASES CHARCOAL RTG SKU # STYLE # ITEM DESCRIPTION 35940407 40G-703 FULL TOP BUNKBED END 35940407 40G-703 FULL TOP BUNKBED END 36640402 40G-730 6 PC RAILS (2 GUARD & 4 SIDE RAILS) 36840406 40G-707 TWIN CASTER BED HD &...
  • Page 3 ASSEMBLY INSTRUCTIONS STEP 1 CASES ON THE RIGHT CASES ON THE LEFT For Right remove center molding by lifting up then pulling out, then remove third drawer, for Left remove center molding and open the door. STEP 2 Remove fastening board and save for next step. STEP 3 RIGHT SIDE CASES LEFT SIDE CASES...
  • Page 4 ASSEMBLY INSTRUCTIONS STEP 5 STEP 4 Assemble loft chest, loft bookshelf and top bunk bed ends. Assemble top side rails. STEP 6 STEP 7 Install slats, one on each end, two equally spaced in the middle, Assemble guardrails and tighten all bolts. then fasten with 1 1/4"...
  • Page 5 ASSEMBLY INSTRUCTIONS STEP 10 STEP 11 Install casters in headboard and footboard, and set rail cup. Slide Caster bed under Loft bed as shown. STEP 13 STEP 12 Screw ladder hooks to pre-drilled holes on top of ladder. Screw ladder to guardrail as shown. 11/7/2022 Page 95 of 97...
  • Page 6 ASSEMBLY INSTRUCTIONS STEP 14 Place Bunkie boards (required, sold separately) on top of the slats Use only correct mattress dimensions and Bunkie board: Twin size mattress- 74" - 75" long and 37-1/2" - 38-1/2" wide Twin size Bunkie board- 74" long and 37-1/2" wide Full size mattress- 74"...
  • Page 7 ASSEMBLY INSTRUCTIONS STEP 15 STEP 16 Remove center molding by lifting up then pulling out Unfold desk leg and look for hardware pack inside desk box. STEP 13 STEP 12 Secure each corner block with 1 1/4" screw Unfold corner supports (from desk box hardware pack) in the pre-bore hole.

This manual is also suitable for:

Kids creekside 2.0 3954441p

Table of Contents