Knox eKEY Quick Start Manual

Knox eKey is an electronic key used to access and collect audit
trails from products equipped with Knox eLocks.
This guide provides a brief overview for Knox Device
Administrators for setting up, programming, charging, and using
the Knox eKey.
Proper charging of the Knox eKey is required for best
performance and battery life. Each eKey must charge a
minimum of 8 hours every six months. Charging is recorded in
KnoxConnect. Battery failures during the warranty period are
covered for eKeys charged to this standard.
Before initial use, the Knox eKey and key control devices must be
configured and user PINS (408 digits) must be assigned to the
devices. These functions are performed in KnoxConnect.
KnoxDock and Knox Holsters are used with the KnoxDock PC app.
KeySecure and KeyDefenders are updated using Knox Device Sync.
CHARGING AND PROGRAMMING USING A
KNOXDOCK OR KEYDEFENDER HOLSTER
1.
Charge Knox eKey by using the provided USB cable to connect the
KnoxDock or holster to a computer).
2.
Insert the Knox eKey into the cradle or holster so the charging pads on
the key's back align with the device's charging pins.
3.
Charge Knox eKey for eight (8) hours before initial use.
•
The Knox eKey will flash green to solid red to show it is charging.
When fully charged, only the solid red LED will be on. A solid red LED
shows the eKey requires activation for use.
4.
To program the Knox eKey, with the eKey in a KnoxDock or holster
connected to a PC as described in Steps 1 and 2, log into and run the
KnoxDcok PC software. Any pending firmware, configuration, and PIN
updates will automatically be pushed to the eKey.
CHARGING AND PROGRAMMING USING KEYSECURE® 6
OR KEYDEFENDER
1.
Ensure KeySecure or KeyDefender is powered and online. Follow steps in
the Knox Neworking Guide using Knox Device Sync to update settings and
network templates. The key control unit must remained powered for the steps
below.
2.
Charge the Knox eKey by inserting it into KeySecure® 6 or KeyDefender and
ensure the latch is closed and locked (flashing amber LED lights are OFF).
3.
Charge Knox eKey for up to eight (8) hours before initial use.
•
The Knox eKey will flash green to solid red while charging. When fully
charged, the light will turn to solid red.
4.
To program Knox eKey, update settings and lock codes in KnoxConnect. Insert
the eKey into a key control device. Ensure the key control device is online
5.
Knox eKey will automatically be programmed after KnoxConnect syncs.
1601 W. DEER VALLEY RD. PHOENIX, AZ 85027
©Knox Company. All rights reserved.
| T. 800-552-5669 | F. 623-687-2290
KNOX eKEY
QUICK START GUIDE
| TECHSUPPORT@KNOXBOX.COM
™
| KNOXBOX.COM
OPE-ESYSLR-0321-D