Pin Assignment for Active Sensors with ±5V or ±10V Signal Pin Assignment for Active Current Sensors with mA Signal Option Digital Input at Channel B Pin Assignment for Auxiliary Supply and Digital Input Application Example Displacement Sensor Potentiometric (supplied by LCV-USB3) Debugging Technical Data Options Calibrations mV/V...
These operating instructions do not constitute an agreed quality agreement or durability guarantee within the meaning of § 443 BGB (German Civil Code). Technical changes, errors and misprints excepted. No part of this publication may be reprinted without the written permission of Lorenz Messtechnik GmbH, Alfdorf. Important Notes / Keeping Before installing and commissioning the device, these operating instructions, and in particular the corresponding safety instructions, must be read.
Page 4
The devices do not contain any parts that require or can be serviced by the user. Repairs may only be carried out by Lorenz Messtechnik GmbH. If it can be assumed that safe operation of the device is no longer possible, it must be put out of operation immediately and secured against unintentional operation.
Intended Use Devices from Lorenz Messtechnik GmbH are to be used exclusively for measuring tasks and the di- rectly associated control tasks. Any use beyond this is considered to be improper. The valid legal and safety regulations must be observed during measurement. The instrument is not a safety component in the sense of its intended use and it is transported and stored properly.
Conversions and Changes The device may not be modified in terms of design or safety without the express consent of Lorenz Messtechnik GmbH. Any modification excludes any liability on our part for damages resulting there- from. Repairs and modifications are prohibited. CE Marking With the CE marking, Lorenz Messtechnik GmbH guarantees that its product meets the requirements of the relevant EC directives. Preamble Product Description The LCV-USB3 is a measurement amplifier for the conversion of analog signals into digital measured values. These measured data can be requested through the Computer via the USB-interface.
If the LCV-USB3 is calibrated together with the sensor, you can take the output values from the test certificate. If the LCV-USB3 is calibrated without a sensor, you can take the output values as described above. In this case, they are pre-calibrated with a high precision source.
Application Example Displacement Sensor Potentiometric (supplied by LCV-USB3) - With “active sensors” only (type: U5) - Accuracy is depending on the quality of the reference voltage 5V reference voltage controller Signal+ Signal+ 0V / GND 0V / GND Output 0 … 20000 digits Output 0 …...
Install driver package LCV-USB3 is not possible stalled • The first start-up LCV-USB3 must be carried out with administrator rights Supply voltage is over- • Check whether the connected strained in such a way that it sensor corresponds to the speci-...