Advertisement
Low-Profile Oil Cooler Adapter
for LS Engines, Rear Sump
Part No. EGM-106
Made in USA
Important: Read these instructions
in their entirety prior to installation.
For contact information, visit www.improvedracing.com
Copyright © 2008-2016 Improved Racing Products, LLC. All rights reserved.
Rev 160923
Advertisement
Table of Contents
Related Manuals for Improved Racing EGM-106
Summary of Contents for Improved Racing EGM-106
- Page 1 Low-Profile Oil Cooler Adapter for LS Engines, Rear Sump Part No. EGM-106 Made in USA Important: Read these instructions in their entirety prior to installation. For contact information, visit www.improvedracing.com Copyright © 2008-2016 Improved Racing Products, LLC. All rights reserved. Rev 160923...
- Page 2 DESCRIPTION EGM-106 LS Oil Cooler Adapter 2 (OPTIONAL) OM-08-XX -AN Adapter Fitting HGA-1000 Bypass Cover Gasket PP-02 Pre-Sealed 1/8” NPT Plug HSC-1004 M6 Socket Screw For contact information, visit www.improvedracing.com Copyright © 2008-2016 Improved Racing Products, LLC. All rights reserved.
- Page 3 Be sure to remove the factory gasket shown in Figure 1. GASKET COVER SCREWS Figure 1 - Removing the oil port cover, retaining screws and gasket 5. Measure and assemble oil cooler system lines. Leave the lines discon- nected from the adapter and oil cooler. For contact information, visit www.improvedracing.com Copyright © 2008-2016 Improved Racing Products, LLC. All rights reserved.
- Page 4 Improved Racing recommends using a 60º, 90º or 120º fitting for the OUT port and a 90º fitting for the IN port. Installing the Oil Cooler Adapter 1. Install the provided NPT plugs into the oil cooler adapter using a 3/16” hex-drive key/bit if not using a sensor. DO NOT overtighten.
- Page 5 11. Reinstall any underbody panels and lower the vehicle back onto the ground. Congratulations! The installation of your oil cooler adapter is now com- plete. For contact information, visit www.improvedracing.com Copyright © 2008-2016 Improved Racing Products, LLC. All rights reserved.
Need help?
Do you have a question about the EGM-106 and is the answer not in the manual?
Questions and answers