Table of Contents
Advertisement
NAME OF PARTS
Remote controller
Display panel
1 MODE button
2 10°C HEAT button
3 SET TEMP. button (
4 ECONOMY button
5 SLEEP button
6 FAN button
7 START/STOP button
8 SET button
9 SWING button
0 TIMER MODE button
A TIMER SET (
B CLOCK ADJUST button
C RESET button
D TEST RUN button
This button is used when installing the
●
conditioner, and should not be used under
normal conditions, as it will cause the air
conditioner's thermostat function to operate
incorrectly.
If this button is pressed during normal op-
●
eration, the unit will switch to test operation
mode, and the indoor unit's OPERATION in-
dicator lamp and TIMER indicator lamp will
begin to fl ash simultaneously.
To stop the test operation mode, press the
●
START/STOP button to stop the air condi-
tioner.
/
)
/
) button
Display panel
To facilitate explanation, the accompanying illustration has
been drawn to show all possible indicators; in actual oper-
ation, however, the display will only show those indicators
appropriate to the current operation.
E Signal transmitter
F Temperature SET indicator
G Operating mode indicator
H SLEEP indicator
I Transmit indicator
J Fan speed indicator
K SWING indicator
L Timer mode indicator
M Clock indicator
Some indoor units may not be equipped with the functions
corresponding to all of the buttons on this remote control-
ler. The indoor unit will beep and the OPERATION, TIMER
and ECONOMY lamp fl ash when a remote controller but-
ton is pressed if the function is not available.
En-5
Advertisement
Table of Contents
