Table of Contents
Advertisement
•
Remove the terminal block cover plate.
•
Insert the power cord with a UL-listed strain relief through the hole provided in the cabinet near the
terminal block.
•
A strain relief must be used.
•
Do not loosen the nuts already installed on the terminal block. Be sure they are tight.
•
Use a 3/8" (1 cm) deep well socket.
•
Since january 1, 1996, The national electric code requires that new wiring (not existing) utilize a 4-wire
connection to this dryer.
STEP 2 Level the dryer
Before you install the dryer, make sure you have read the Installation requirements on
page 9. Please note that the following instructions are for installation without using a
drain hose. For instructions on using a drain hose, see the next section, Drain hose (if
necessary) on page 20. For convenience, consider installing the dryer next to your washer.
B
DV6900B_SimpleUX_WEB_Heatpump_EN.indd 23
1. Carefully move the dryer to the desired location.
A
2. Use a level (A) and check the levelness of the
3. If the dryer is not level, adjust the levelling legs
4. Once the dryer is level, make sure the dryer
5. Plug in the dryer.
dryer from side to side and front to back.
(B). Turning a leg counter-clockwise retracts the
leg. Turning a leg clockwise extends the leg.
stands firmly on the floor.
English 23
2022/8/30 17:01:55
Advertisement
Table of Contents
