Advertisement
Alarm setting dial
Downloaded from:
https://www.usersmanualguide.com/
Set t ing t he Clock
and Dat e
1
Set the alarm setting dial to ALARM
M ODE OFF.
2
Plug in the clock radio.
The display will flash "AM 12:00".
3
Press CLOCK for a few seconds.
You will hear a beep and the year will start to
flash in the display.
4
Press CLOCK + or – until the correct
year appears in the display.
5
Press CLOCK once.
6
Repeat steps 4 and 5 to set the month,
day, hour, and minute.
After setting the minute, press CLOCK to start
the counting of the seconds, and you will
hear two short beeps.
• To display the year and date, press SNOOZE/
DATE/ SLEEP OFF once for the date, and within
2 seconds press it again for the year. The
display shows the date or year for a few
seconds and then changes back to the current
time.
FM w ire antenna
• To set the current time rapidly, hold down
CLOCK + or – .
• In step 6 , when you press CLOCK after the
minute setting to activate the clock, the seconds
start counting from zero.
AC pow er cord
• When the alarm setting dial is set to ALARM
TIM E SET A or B , the clock cannot be set.
To change t he display t o t he
daylight saving t im e (sum m er t im e)
indicat ion
Press D.S.T./ SUM M ER T.
"
" is displayed and the time indication
changes to summer time.
To deactivate the summer time function, press
D.S.T./ SUM M ER T. again.
Playing a CD
An 8 cm (3-inch) CD can be played without an
adaptor.
1
Push OPEN/CLOSE to open the CD
compartment lid and place a disc.
2
Close the CD compartment lid.
Push
Labeled surface up
Close the lid
3
Press CD u.
" CD N" and "01" appear on the display to
indicate that track 1 of the CD is playing.
4
Turn VOLUM E to adjust the volume.
To
Press
Pause
CD u
Resume play after
CD u again
pause
Locate the beginning
.**
of the current
track (AMS*)
Locate the next
>**
track (AMS)
Go back at high speed
Hold down .**
Go forward at high
Hold down >**
speed
Locate the previous
. repeatedly**
track (AMS)
Locate the succeeding
> repeatedly**
track (AMS)
Stop play
OFF• ALARM RESET
* AMS = Automatic Music Sensor
**These operations are possible during both play
and pause.
•To handle compact discs
Correct
Handle the disc
by its edge.
The display shows the frequency for a few
seconds and then changes back to the current
time.
For the radio alarm, preset the station to be used
Incorrect
as the alarm onto preset button 1 .
Do not touch the
To change a preset st at ion
surface.
Tune in manually to the station you want to store
and hold down the preset button until you hear
two short beeps. The previously stored station
will be replaced by the new one.
Do not stick paper or
tape nor write
Tuning in t o a preset st at ion
anything on the
1
Press RADIO• SLEEP to turn on the
surface.
radio.
Not e
2
If you press CD u when there is no disc in the
Press the STATION• SELECT/PRESET
CD compartment, "00" flashes for about 5
button where the desired station is
seconds on the display and the unit turns off
stored.
automatically.
3
Adjust the volume using VOLUM E.
Various M odes of CD
After a few seconds, the display returns to
Playback
the current time but the preset button
number remains.
You can play tracks repeatedly or in random
order.
Set t ing t he Alarm
Press CD PLAY M ODE.
This radio is equipped with 3 alarm modes —
Each press changes the play mode as
CD, radio and buzzer. Before setting the alarm,
follows:
make sure to set the clock (see "Setting the
Clock").
Display
Play
indication
mode
To Set t he Alarm Tim e
none
(normal play)
<
To set t he
All the tracks are played once.
1
Set the alarm setting dial to ALARM
m
TIM E SET A (CD).
"REP 1"
(single repeat)
After one beep,
A single track is played repeatedly.
set in the previous time will flash in the
m
display.
"REP ALL"
(all repeat)
2
Press CLOCK + or – until the desired
All the tracks are played repeatedly.
time appears.
m
When CLOCK + or – is held down, the
"SHUFFLE"
(shuffle play)
displayed time initially changes in one-
All the tracks are played once
minute steps, and after a few seconds,
in random order.
switches to ten-minute steps.
m
3
"SHUFFLE REP" (shuffle repeat)
Set the alarm setting dial to ALARM
All the tracks are played repeatedly
M ODE OFF . Two short beeps will
in random order.
confirm the setting.
To set t he
Playing t he Radio
1
Set the alarm setting dial to ALARM
TIM E SET B (radio or buzzer).
M anual Tuning
After one beep, "
1
and the alarm time set in the previous time
Press RADIO• SLEEP to turn on the
will flash in the display.
radio.
"RADIO" appears in the display.
2
Press CLOCK + or – until the desired
The display shows the band and frequency
time appears.
for a few seconds and then changes back to
When CLOCK + or – is held down, the
the current time.
displayed time initially changes in one-
2
Press BAND repeatedly to select the
minute steps, and after a few seconds,
desired band.
switches to ten-minute steps.
3
Use TUNING + or – to tune in to the
3
Set the alarm setting dial to ALARM
desired station.
M ODE OFF. Two short beeps will
The FM frequency advances or reverses in
0.1MHz channel steps and the AM frequency
confirm the setting.
in 10kHz channel steps.
• When the alarm setting dial is set to ALARM
Two short beeps sound when the minimum
TIM E SET A or B , the sound of the CD or the
frequency of each band is received during
radio will be interrupted.
tuning.
4
Adjust volume using VOLUM E.
To Set t he Alarm M ode
• To turn off the radio, press OFF• ALARM
RESET .
Before setting the alarm mode, be sure to set the
• To improve radio reception
alarm time. (See "To Set the Alarm Time".)
FM : Extend the FM wire antenna fully to
Set the alarm setting dial to the desired alarm
increase reception sensitivity.
AM : Rotate the unit horizontally for optimum
mode (A, B, or A+B). When the alarm setting
reception. A ferrite bar antenna is built
dial is set to ALARM M ODE B or A+B, you can
into the unit.
choose
modes in ALARM B.
Do not operate the unit over a steel desk
According to the alarm mode that you set,
or metal surface, as this may lead to
interference of reception.
,
the display.
• To check the station being received, press
TUNING + or – lightly. The display shows the
band and frequency for a few seconds and
Alarm
then changes back to the current time.
• If the radio alarm comes on while the radio is
on, the unit switches to the station on preset
CD
button 1 ( WAKE UP STATION ).
Preset Tuning
Radio
You can preset up to 5 stations; one station for
Buzzer
each preset buttons 1 to 5 , for one-touch tuning.
Preset t ing a st at ion
CD and ALARM M ODE
Example: To preset AM 1260 kHz onto preset
Radio
button 2 .
CD and ALARM M ODE
1
Press RADIO• SLEEP to turn on the
Buzzer
radio.
2
When the radio alarm is activated, the radio
Tune in to the station on AM 1260 kHz
station that is preset on the preset button 1
(See "Manual Tuning").
( WAKE UP STATION ) turns on at the preset time.
3
Hold down the desired
For the radio alarm, make sure you have preset a
radio station onto preset button 1 (See "Preset
STATION• SELECT/PRESET button (in
Tuning").
this case, 2) until you hear two short
beeps.
To Set t he Wake Up
Track
1
Press WAKE UP TRACK for a few
seconds until you hear a beep.
The track number flashes on the display.
2
Press TUNING + or – to select the
desired track number.
The track number can be set up to 99.
3
Press WAKE UP TRACK again.
Two short beeps sound to confirm the
setting.
To Check t he Alarm
Tim e
Press ALARM TIM E CHECK.
The display shows the alarm time for a
few seconds and then returns to show the
current time.
When the alarm setting dial is set to either
ALARM M ODE OFF or ALARM M ODE
A+B, the alarm time in ALARM M ODE A
and then ALARM M ODE B appears in
the display.
• Alarm time in ALARM M ODE A and ALARM
M ODE B is set at AM 12:00 when you
purchased the unit.
ALARM ON—
When the alarm comes on at the preset time,
"
", "
in the display.
For the buzzer alarm, the beeping of the alarm
alarm :
becomes more rapid after every few seconds in
five progressive stages.
• When CD and radio, or buzzer alarms are set
for the same time, and you choose ALARM
"
"
and the alarm time
M ODE A + B , the CD alarm takes precedence.
Not e
If you set the CD alarm and there is no disc in
the CD player, the buzzer alarm will sound in its
place at the time set.
To Doze f or a Few M ore
M inut es
Press SNOOZE/DATE/SLEEP OFF.
The CD, radio or buzzer alarm turns off but will
be automatically activated again after about 8
minutes. Every time you press SNOOZE/ DATE/
SLEEP OFF , the snooze time changes as follows:
or
alarm :
8
16
40
The display shows the snooze time for a few
" or "
"
seconds and returns to show the current time.
When you press SNOOZE/ DATE/ SLEEP OFF
after the current time appeared, the snooze time
starts from 8 minutes again.
• The maximum length of the snooze time is 60
minutes.
ALARM OFF—
The alarm is turned off automatically after 60
minutes.
To St op t he Alarm
Press OFF• ALARM RESET to turn off the
alarm.
The alarm will come on again at the same time
the next day.
To Cancel t he Alarm
Set the alarm setting dial to ALARM
M ODE OFF.
Set t ing t he Sleep
Tim er
You can enjoy falling asleep to the radio using
or
by switching the
the built-in sleep timer that turns off the radio
automatically after a preset duration.
Press RADIO• SLEEP.
, or
will appear in
The radio turns on. You can set the sleep timer
to durations of 90, 60, 30, or 15 minutes. Every
push changes the display as follows:
Set the alarm
Set
Display
On
setting dial to
ALARM B to
15
ALARM
––––––
M ODE A
Two short beeps sound when the display returns
to "On".
ALARM
RADIO
"SLEEP" will appear in the display when the
M ODE B
duration time is set.
ALARM
The radio will play for the time you set, then
BUZZER
M ODE B
shut off.
• To turn off the radio before the preset time,
RADIO
press SNOOZE/ DATE/ SLEEP OFF .
A + B
To Use Bot h t he Sleep
BUZZER
A + B
Tim er and t he Alarm
You can enjoy falling asleep to the radio and be
awakened by the CD, radio or buzzer alarm.
1
Set the alarm. (See "Setting the
Alarm".)
2
Set the sleep timer. (See "Setting the
Sleep Timer".)
", or "
" flashes
24
32
56
60
48
90
60
30
Advertisement
