TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product, and/or company names may be trademarks of their respective owners.
SDE-SA Commercial Hand Tool Assembly
PN 2405500-1 with
Die Assembly PN 2405500-2
1
5
Die set 2405500-2
2
6
Upper hex die
3
7
Lower hex die
4
8
Stationary jaw
PRODUCT INFORMATION 1-800-522-6752
Moving jaw
Ratchet adjustment wheel
Die-retaining screws
Handle
This controlled document is subject to change.
For latest revision and Regional Customer Service,
Page 1
A wide selection of powered application equipment is available for extended-use production operations. The SDE-SA hand tool is a commercial-grade tool. Product crimped with this tool meets the wire barrel crimp height requirement for hand tools in the appropriate 114 application specification, but might not comply with other feature parameters of the specification.
Page 2
1. INTRODUCTION SDE-SA Commercial Hand Tool Assembly 2389146-1 for the Contact Kit, Ferrule, RG58; RTK031; RG174 is the tool and die set shown in Figure 1. The tool consists of the SDE Crimp Hand Tool Frame 2362810-1 (instruction sheet 408-35143) and the die assembly listed in Figure 1. This tool is used to crimp the terminal part numbers listed in Table 1.
Page 3
4. REMOVING THE DIE SET 1. Close the tool handles until the ratchet releases. 2. Remove the two die-retaining screws. 3. Slide the dies out of the tool jaws. NOTE The ratchet release has detents with audible clicks as the handles are closed. The ratchet releases on the sixth click. 5.
Page 4
Crimp height inspection is performed using a micrometer with a modified anvil, commonly referred to as a crimp-height comparator. TE Connectivity does not manufacture or market crimp height comparators. Detailed information on obtaining and using crimp-height comparators can be found in instruction sheet 408-7424.
Page 5
7. ADJUSTING THE RATCHET The ratchet is preset prior to shipment, but it is important to verify the crimp height using a micrometer or caliper. Use and wear can cause the tool to go out of adjustment. Inspect the crimp height and adjust the ratchet, if necessary, on a regular basis.
Shop TE link at the top of the page. Call 800-522-6752. Write to: CUSTOMER SERVICE (038-035) TE CONNECTIVITY CORPORATION PO BOX 3608 HARRISBURG PA 17105-3608 For customer repair services, call 800-522-6752. 10. REVISION SUMMARY Revisions to this instruction sheet include:...