Installing The Multipurpose Blade Or Dough Blade; Operating The Food Processor - KitchenAid 5KFP0921E Owner's Manual

4.
Once the Work Bowl Cover is closed, push the Lid Hinge down into the locked position.
NOTE: Your Food Processor will not operate unless the Work Bowl Cover is fully closed
and the Work Bowl is properly seated on the Base.

INSTALLING THE MULTIPURPOSE BLADE OR DOUGH BLADE

1.
Place the Blade on the Drive Adapter. Rotate the Blade so it falls down to the base of the
Adapter.
2.
Install the Work Bowl Cover, and be sure the Lid Latch is pushed down to the locked
position.
INSTALLING THE REVERSIBLE SLICING/SHREDDING DISC OR
JULIENNE DISC
1.
To slice: Turn the Disc so that the raised Slicing Blade is facing up.
To shred: Turn the Disc so that the small, raised Shredding Blades are facing up.
To julienne: Insert the Disc so that the raised Slicing Blade is facing up.
The Disc can be placed in two different positions: High at the top of the Bowl for
processing, and lower, inside of the Bowl for storage.
NOTE: While the Disc will operate in storage position, it will not perform as well. Make sure
the Disc is level with the top of the Bowl for best performance.
2.
Hold the Disc by its centre hub and lower it onto the Drive Adapter, aligning the marks on
the centre hub of the disc to the marks on the adapter. When properly placed, the Disc
should be level with the top of the Bowl. If the Disc falls to the storage position, lift it out,
turn it 90°, and lower it again.
3.
Install the Work Bowl Cover, be sure the Lid Latch is pushed down to the locked position.
USING THE JULIENNE DISC
1.
Insert Julienne Blade into processor with the blade facing up. Close the Lid Latch to
secure position.
2. Prepare ingredients by cutting into about 25 mm sections, short enough for the vegetable
to fit into the Feed Tube.
3.
Stack ingredients into Feed Tube horizontally with processor off.
4.
Place Food Pusher on top of ingredients to apply light pressure, then turn on unit to 1 or 2
(see table for instructions on which setting to use).

OPERATING THE FOOD PROCESSOR

Always use food pusher.
Keep fingers out of openings.
Keep away from children.
Failure to do so can result in amputation or cuts.
Before operating the Food Processor, be sure the Work Bowl, Blades, and Work Bowl Cover
are properly assembled on the base (see the "Assembling the Food Processor" section).
1.
To turn on, press 1 or 2. The Food Processor will run continuously and the indicator light
will glow.
To turn off, press 1 or 2 again, or press O/Pulse.
6
WARNING
Rotating Blade Hazard