Clatronic SMS 2759 Instruction Manual page 43

5....-05-SMS 2759 neu
9. The device switches itself off when the button is released.
10. Pull out the plug from the socket after use. Clean and put the device away as
described in „Cleaning and Maintenance".
Changing of the metal attachments
• Remove the attachment already inserted on the shaft of the mixing rod (4) with
the release button (15).
• The side with the slot is used to remove the attachments.
1. Make sure that the appliance's plug is not inserted in the socket!
2. Release the mixing rod (4) by turning it and pulling it out of the motor housing (3).
3. Place the multiple chopping machine on a flat, level surface and then remove
the lid (12).
4. Fill the transparent beaker (13). Do not fill the beaker to the rim, but only 3/4 of
the beaker capacity.
5. Seal the bowl again with the lid; the recesses on the lower edge of the lid and
on the upper edge of the bowl must interlock.
6. Place the motor casing on the upper opening of the lid and fasten the multi-
chopper by turning it to the right.
7. Only connect the machine to a properly installed safety socket, 230 V/50 Hz.
Allow the multiple chopping machine to stand on this surface during operation
and until the chopping blade is removed (14). Hold the multi-chopper firmly with
a hand.
8. Press one of the buttons on the two-level control switch. You can achieve pulse
operation by pressing the button at intervals and then releasing it.
9. Remove the mains plug from the socket after use. Release the motor housing
from the multiple chopping machine by turning it and then remove it from the lid.
10. Remove the lid and pull the chopping blade (14) out carefully. CAUTION: The
chopping blade is very sharp! DANGER OF INJURY!
11. Pour the contents of the beaker into a container or plate.
12. Clean the appliance as described in „Cleaning and Storage".
• Always pull the plug out of the socket before cleaning!
• Removable parts which have come into contact with food (utensils and bowls)
can be cleaned in soapy water.
• In order to clean the mixing rod fill the mixing bowl with water and operate the
mixing rod as described under "Using the Device". Then dry the mixing rod
thoroughly.
• Rub the outside of the motor casing with a moist towel to clean it when neces-
sary and then wipe it with a dry cloth.
• After cleaning, store the mixing rod in the wall mounting supplied.
15.01.2003 9:55 Uhr
Using the Multi-chopper
Cleaning and Maintenance
Seite 43
GB
43