Gigabyte H370N WIFI User Manual page 42

A-2: Installation in Intel RST Premium With Intel Optane System Acceleration mode
If the SATA controller has been configured in Intel RST Premium With Intel Optane System Acceleration mode,
please follow the steps below:
1. After system restarts, go to the BIOS Setup, make sure CSM Support under the BIOS menu is disabled.
2. Go to Peripherals\SATA And RST Configuration and make sure Use RST Legacy OROM is disabled. If
you want to enable the Optane
Port 9 to RST Controlled; to enable the Optane
Dev on Port 21 to RST Controlled.
3. Enter the operating system, launch the Intel
Memory on the Intel
enable Intel Optane
® ™
4. If you install more than one Optane
5. Follow the on-screen instruction to continue the installation and then restart the system when completed.
• An Optane memory cannot be used to accelerate an M.2 PCIe SSD.
™
• If more than one Optane
SATA-based boot drive. The other(s) can only be used as data drive(s).
• Do not abruptly remove the Optane
functioning correctly.
• If you want to change/remove the Optane
Storage Technology or Intel(R) Optane
• After enabling the Optane
memory installed in the M2P_32G connector, set PCIe Storage Dev on
™
memory installed in the M.2 connector, set PCIe Storage
™
Rapid Storage Technology utility from the Start menu, and then
®
Optane Memory screen.
® ™
memory, please select which one you are going to use.
™
memory is installed, you can select only one of them to accelerate your
™
memory. Doing so will cause the operating system to stop
™
memory, you must disable it using the Intel
™
Memory application first.
™
memory, the related BIOS settings will remain even after a BIOS update.
™
- 42 -
Rapid
®