Peripherals - Gigabyte H370N WIFI User Manual

2-6

Peripherals

& Initial Display Output
Specifies the first initiation of the monitor display from the installed PCI Express graphics card or the onboard
graphics.
Sets the onboard graphics as the first display.
IGFX
PCIe 1 Slot Sets the graphics card on the PCIEX16 slot as the first display. (Default)
& OnBoard LAN Controller (LAN2)
Enables or disables the onboard LAN function. (Default: Enabled)
If you wish to install a 3rd party add-in network card instead of using the onboard LAN, set this item to
Disabled.
& EZ RAID
Allows you to quickly set up a RAID array. Refer to Chapter 3, "Configuring a RAID Set," for instructions
on configuring a RAID array.
& Above 4G Decoding
Enables or disables 64-bit capable devices to be decoded in above 4 GB address space (only if your system
supports 64-bit PCI decoding). Set to Enabled if more than one advanced graphics card are installed and
their drivers are not able to be launched when entering the operating system (because of the limited 4 GB
memory address space). (Default: Disabled)
& RGB Fusion
Allows you to set the LED lighting mode for the motherboard.
Disables this function.
Off
Pulse Mode All LEDs simultaneously fade in and fade out.
Color Cycle All LEDs simultaneously cycle through a full spectrum of colors.
Static Mode All LEDs emit a single color. (Default)
Flash Mode All LEDs simultaneously flash on and off.
Double Flash All LEDs flash in an interlaced pattern.
& LEDs in Sleep, Hibernation, and Soft Off States
Allows you to set the lighting mode of the motherboard LEDs in system S3/S4/S5 state.
This feature is supported only with a 5V digital LED strip.
Disables the selected lighting mode when the system enters S3/S4/S5 state. (Default)
Off
Enables the selected lighting mode when the system enters S3/S4/S5 state.
On
- 32 -