Advertisement
fig.1
5. ASSEMBLY
1. Base plate
2. Quick clamp
3. Column
4. Toothed rack for height adjustment
5. Clamping lever for height adjustment
6. Clamping lever for depth stop
7. Depth stop
5.1.
ASSEMBLING THE BASE PLATE AND COLUMN (fig.2)
5.1.1.
Insert the quick release clamp (2) over the column (3).
5.1.2.
Locate the column (3) into the base plate (1) so as the guide
pins on the bottom end of the column (3) engage with the grooves,
on the bottom of the base plate (1).
5.1.3.
Secure the grub screws (A) on the rear of the base plate (1) with
the hex key (19). This may need a further adjustment on completion
to align laser light to ensure centralisation of the laser.
5.2.
FITTING THE GUIDE / STOP (fig.3)
5.2.1.
Slide the guide / stop (16) into the grooves in the base
plate (1).
5.2.2.
Ensure that the sliding blocks underneath the winged screws of
the guide / stop (15) are properly engaged in the grooves
of the base plate.
5.2.3.
Move the guide / stop (16) to the desired position and tighten
the winged screws of the guide / stop (15) firmly.
5.3.
FITTING THE CHUCK GUARD (FIG.2)
5.3.1.
Insert the chuck guard (13) into the holes provided in the
machine frame.
5.3.2.
Fit the chuck guard (13) and tightening the screws (C).
5.4.
HANDLE FITMENT (fig.2)
5.4.1.
Slide the handle (8) onto the retainer (D) as shown in fig.2.
5.4.2.
Place the handle (8) on the retainer (D) with the flattened.
part at the side of the fastening screw (B).
5.4.3.
Tighten the fastening screw (B) with the hex key (19).
5.5.
FITTING THE DEPTH STOP (fig.2)
Insert the depth stop (7) into the hole provided in the housing.
5.6.
CLAMPING LEVER FOR DEPTH STOP ASSEMBLY (fig. 2)
5.6.1.
Assemble the clamping lever for depth stop (6) as shown in fig.2.
5.7.
SECURING TO A WORK SURFACE (fig.3)
5.7.1.
Fasten the device to the work surface by bolting the base plate (1)
to the work surface.
© Jack Sealey Limited
8. Handle
9. Display
10. Off switch
11. On switch
12. Speed control
13. Chuck guard
14. Chuck
Original Language Version
15. Winged screws for guide / stop
16. Guide / stop
17. Quick clamp lever
18. Gear selector switch
19. Hex key
fig.2
fig.3
PDM10B Issue:2 (3)
06/03/23
Advertisement
