Bunn FMD-1 Cleaning Instructions

CLEANING INSTRUCTIONS for FMD-1 POWDER MIX DISPENSER
NOTICE - This guide is for quick reference only and is not intended to replace the information in the Operation Manual!
RECOMMENDED DAILY CLEANING
1. Empty the Drip Tray and
wash components in a
mild solution of dish de-
tergent using a bristle
brush. Rinse and dry each
item thoroughly before
reassembling.
DISASSEMBLY & CLEANING THE WHIPPER CHAMBER (Once a week)
1. Open the Cabinet Door.
(Door removed for illus-
tration only)
6. Twist Whipper Cham-
ber Receptacle clockwise
and pull it off the Motor
Shaft.
35111.0000A 11/02 ©2002 Bunn-O-Matic Corporation
RELEASED FOR PRODUCTION
J1
2. Rinse out the Whipper
Chambers by placing the
RINSE/RUN switch in the
RINSE position and acti-
vating the DISPENSE
switch for 5 to 10 second
bursts.
2. Remove the steam col-
lector by pulling it forward
and twisting in a clock-
wise rotation.
7. Slip the O-ring off the
Whipper Chamber Recep-
tacle and remove the shaft
seal.
DIR Num: 35111.0000
3. Remove Hoppers and
refill with product.
3. Pull the Mixing Cham-
ber out of the Whipper
Chamber.
8. Wash components in a
mild solution of dish de-
tergent using a bristle
brush. Rinse and dry each
item thoroughly before
reassembling.
19, May 2015
4. Twist the Whipper
Chamber clockwise and
pull it off the Whipper
Chamber Receptacle.
5. Pull the Frother off the
Motor Shaft. Notice the
flat keyway on the shaft
and the matching keyway
inside the Frother. It is
important that these two
keyways are lined up
when reassembling.