Operating and installation instructions
WMS Socket
Keep for future use!
Valid from 1 september 2021
General information
Fig. 1
WMS Socket
The WMS socket enables the wireless remote control of
lamps with a conventional safety plug. The installation
does not require electrical setup work: The WMS Socket is
simply inserted in the existing plug-in connection.
The WMS Socket can receive switch commands from
WMS transmitters, e.g. a WMS Hand-held transmitter, WMS
Central transmitter or WMS Weather station. Feedback on
the received commands is provided via the transmitter.
The switching states for the comfort and scene control and
the parameters for the control functions are stored directly
in the socket and can be recalled or changed at any time.
Intended use
The WMS Socket is an electronic device that was devel-
oped to switch on and off the power operating voltage
of lamps with a safety plug. The device is only permitted
to be connected to permanently installed safety sockets
intended for this purpose.
The approval of the manufacturer must be obtained for
uses outside of the purposes listed in these instructions.
warema_890587_alhb_en_v6•2021-09-01
Safety instructions
W
ARNING
The WMS Socket may only be operated in
dry rooms.
W
ARNING
Power consumers that result in a danger
due to motion, heat, fluids, etc., when they
are switched on are not permitted to be
connected. This is especially important
since the WMS Socket can be automat-
ically switched by time or sensor com-
mands. Warema cannot be held liable for
personal injury or property damage result-
ing from this.
W
ARNING
If hazard-free operation cannot be
assumed, the device may not be commis-
sioned or must be decommissioned. This
assumption is justified if
The housing or plug-in connections show
signs of damage
The device is no longer working.
W
ARNING
Disconnect the power plug of the product
connected to the WMS Socket if you are
going to perform cleaning or maintenance
or change the lighting equipment. Danger
from electric shock!
C
AUTION
Never activate buttons on your transmitter
arbitrarily without visual contact to the con-
nected lamp. Children must not play with this
product – remote controls or transmitters
must not get into the hands of children!
W
ARNING
It is not permissible to connect devices in
series.
We reserve the right to carry out improvements
1