Glasdon C-Thru Operating And Assembly Instruction

C-Thru
OPERATING AND ASSEMBLY INSTRUCTIONS
IMPORTANT NOTE: ENSURE ALL RELEVANT PERSONNEL READ THESE INSTRUCTIONS PRIOR TO OPERATION.
1. LINER INSTALLATION
1.1 Ensure the illustration on the
key is uppermost.
1.3 With the key still in position,
turn hood counter-clockwise,
then lift hood off. Remove the
key.
2. UNIT DISASSEMBLY
2.1 Remove hood as (1) above,
remove sack if present. Insert
the plastic key into the lock.
™
RECYCLING UNIT
1.2 Push the key all the way into the
lock.(Do not turn the key). This
will automatically release the
locking mechanism.
1.4 Place a clear sack into the
body and hook over the rim
with approximately 2 inches
overhang.
2.2 Hold the body with both hands,
twist counter-clockwise and lift
away from the base. Remove the
key and keep safely.
Lock housing
Front bobbin
1.5 Place the hood onto the body and
align the lock housing with the
front bobbin by turning the hood.
Push the hood fi rmly downward to
automatically lock the unit.
SAFETY NOTE: We would recommend wearing
safety gloves as the edges of
the interlocking mechanism
may be sharp.
2.3 To disassemble the body place
on a well-protected and soft
surface, joint uppermost. Push
down either side of the interlock
to disconnect the tabs, and allow
the sheet to spring fl at.