Table of Contents
Advertisement
5. Getting Started
5-1 Install the Rechargeable Battery
Power the Notebook PC before using it. There are two ways to power the Notebook PC:
Use the AC Adapter to power it or use the removable Battery Pack.
The Notebook PC is designed to work with a removable Battery Pack. Your Notebook PC
may or may not have its Battery Pack installed. If your Notebook PC does not have its Battery
Pack installed, using the following procedures to install the Battery Pack:
Place the Battery Pack into the card-slots of the Notebook PC toward the arrow ①and
then press it toward the arrow ② to Battery Pack.
5-2 Remove the Battery Pack
1.
Turn off the Notebook PC，and disconnect all lines.
2.
Shut down and turn over the computer to access its base in flat and clean work surface.
3.
Slide the Battery Latch toward the arrow ① and slide the Battery Latch toward the arrow
②.
4.
Pull the Battery Pack out from the Notebook PC toward ③.
WARNING! For safety reasons, DO NOT disassemble the Battery Pack, DO NOT
short the circuit, DO NOT throw the Battery Pack into fire and keep it away from
children.
When the Notebook PC with Battery Pack (disconnect the adapter) turns on, the
Power Indicator will turn on. And the light will turn off when in standby mode or
system halting.
DO NOT attempt to remove the Battery Pack while the Notebook PC turns on, as this
may result in the loss of working data.
Damage may occur if you use a different adapter to power the Notebook PC or use
the Notebook PC's adapter to power other electrical devices.
ViewSonic VNB101
8
Advertisement
Table of Contents
