Before Starting The Operation - Hazet 9033 N-6 Operating Instructions Manual

3. Before starting the operation

The pneumatic
always be used, inspected and
maintained in compliance with
the local government, state or
federal regulations.
• Drain the compressor tank and
remove the condensate from the air lines.
Carefully read through the operating instruc-
tions for the compressor.
IMPORTANT:
We recommend using air filters and
a compressed air line lubricator.
ATTENTION!
Disconnect the compressed air sup-
ply prior to lubricating, connecting or
disconnecting the tool.
• Lubricate the tool; see the section on main-
tenance in these operating instructions.
• Remove the dust cap on the compressed air
inlet.
• Connect the tool to a hose of suitable size.
Table on page 17
4. Commissioning
• Switch on the compressor so that the air
tank can be filled.
• Turn the compressor regulator to approx.
90 PSI or 6.2 bar. The max. working pressu-
re of this tool is approx. 90 PSI or 6.2 bar.
• The rotational power may vary depending
on the size of the air compressor and the
volume of the compressed air output.
• Do not use damaged or worn air hoses or
adapters of inferior quality.
• The pressure for achieving the correct tool
speed is regulated by the compressor regu-
lator or a pressure regulator which is to be
installed separately.
• The speed is regulated using an air supply
regulator (not included in delivery).
• The technical data provided refers to an
operation of the tool at a pressure of 6.2 bar.
• Caution is required at all times when using
the sander. Negligent operation may cause
damage to the inner parts or the housing
and limit the working performance.
• Accessory selection and assembly
; Güldenwerther Bahnhofstraße 25 - 29 • 42857 Remscheid •
[ +49 (0) 21 91 / 7 92-0 • \ +49 (0) 21 91 / 7 92-375 • ^ hazet.de • ] info@hazet.de
3
Design and function
tools must
Immer persönliche Schutzausrüstung tragen!
HAZET-WERK Hermann Zerver GmbH & Co. KG
Always wear personal protective equipment!
1. Select the correct brush belt (4 types
available) if you want to remove paint or
rust, for example, or use the appropriate
eraser if you want to remove labels, for
example.
2. To remove paint on
fine/smooth surfaces,
please use the fine brush
belts.
Use the coarse and bent
brush belts accordingly for
coarse/rough surfaces or
cases of severe rust.
3. Mount the belts with the bent brushes in
the direction of rotation.
4. Assemble the two halves of the cor-
responding adapter through the brush
belt or the eraser. Make sure that they
are assembled correctly. Now place the
adapter on the spindle of the sander and
fix it in place with the appropriate screw.
The adapter is adjusted using the inside
6-point on the spindle -
19