Exposure To Radio Frequency Energy - Dometic DMG210 Operating Manual

Marine gateway

Table of Contents

Note Supplementary information for operating the product.

2.3

Supplemental directives

To reduce the risk of accidents and injuries, please observe the following directives before proceeding to

operate this appliance and/or application:

• Read and follow all safety information and instructions.

• Read and understand these instructions before operating this product.

Exposure to radio frequency energy

The radiated output power of this device meets the limits of radio frequency exposure limits of the organi-

zations below.

WARNING! Radio frequency hazard

This device should be operated with a minimum separation distance of 8 in. (20 cm) between

the equipment and a person's body. Failure to obey this warning could result in death or serious

injury.

3.1

Federal Communications Commission (FCC) notice

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

This device may not cause harmful interference.

This device must accept any interference received, including interference that may cause undesired

operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant

to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful in-

terference in a residential installation. This equipment generates, uses and can radiate radio frequency en-

ergy and, if not installed and used in accordance with the instructions, may cause harmful interference to ra-

dio communications. However, there is no guarantee that interference will not occur in a particular installa-

tion. If this equipment does cause harmful interference to radio or television reception, which can be deter-

mined by turning the equipment oﬀ and on, the user is encouraged to try to correct the interference by one

or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connect-

ed.

• Consult the dealer or an experienced radio/ TV technician for help.

Changes or modifications to this product not authorized by Dometic could void the electromagnetic com-

patibility (EMC) and wireless compliance and negate your authority to operate the product.

Table of Contents