Subscribe to Our Youtube Channel
Related Manuals for fine fixtures SDF1
Summary of Contents for fine fixtures SDF1
- Page 1 206 Wembly Road New Windsor, NY 12553 Phone: 718.602.6060 Fax: 718.963.2082 info@finefixtures.com www.finefixtures.com INSTALLATION MANUAL SHOWER PANEL FIXED FRAMELESS MODELS: SDF1-34 TDF1-34 MODEL# SDF1 / TDF1...
- Page 2 READ ALL INSTRUCTIONS BEFORE UNPACKING THE PRODUCT INSTRUCTIONS THAT, IF IGNORED, COULD RESULT IN DEATH OR SERIOUS INJURY CAUSED BY INCORRECT HANDLING OR INSTALLATION OF THE PRODUCT. THESE INSTRUCTIONS MUST BE OBSERVED FOR SAFE INSTALLATION. ATTENTION! PEOPLE ARE REQUIRED TO LIFT AND DURING ENTIRE INSTALLATION OF THIS PRODUCT INSTALLATION OF THIS PRODUCT BY AN INEXPERIENCED INSTALLER MAY RESULT...
- Page 3 COMPONENTS PARTS AND HARDWARE During unpacking the product and prior to installation inspect your new product for any damages or missing parts. Do not attempt to install or operate the product if the product is damaged. Part Plastic Ø8 Anchor Pieces Part Wall...
- Page 4 ATTACHING THE RAIL VERTICALLY Mount the rail (B) on the wall vertically and use a pencil to mark the spots for screws. Keeping rail vertical with a level. Remove the rail and drill holes at the marked points with size 6 drill bit. Insert wall anchors (A) into the holes with the help of a hammer.
- Page 5 ATTACHING THE RAIL HORIZONTALLY Use a measuring tape to mark two points on the floor that are of equal distance from the wall. (Make sure floor is level) Use a size 6 drill bit to drill holes at the marked points on the floor. Insert the wall anchors (A) into the floor, using a hammer.
- Page 6 ATTACHING SEAL STRIPS TO GLASS SIDES Attach the plastic seal strips (C) to a vertical and horizontal side of the glass in an L shape.
- Page 7 ATTACHING THE GLASS TO THE RAIL Once the plastic seals are attached to the glass, affix the glass panel to the rail.
- Page 8 SECURING THE GLASS Secure the glass in the rail, using a caulking gun and high-quality clear silicone caulk. DRYING THE GLASS Let the glass dry for 24 hours. Do not touch, move, or make wet during these hours. AFTER INSTALLATION WAIT 24 HRS BEFORE USE F I N E...
Need help?
Do you have a question about the SDF1 and is the answer not in the manual?
Questions and answers