Using The Projector In Standby Mode; Shutting Down The Projector - ViewSonic PJD6353 User Manual

PJLink™, SNMP, AMX and Xpanel formats supported
This projector is PJLink™, SNMP V.1, AMX or Xpanel V1.10 compliant. For details,
please follow its user guide or website respectively to control and manage projectors.

Using the projector in standby mode

Some of the projector functions are available in standby mode (plugged in but not turned
on). To use these functions, be sure you have turned on the corresponding menus under
SYSTEM SETUP: Basic > Standby Settings, and the cable connections are correctly
made. For the connection methods, see the Connection chapter.
Power Saving
Less than 1W power consumption when Power Saving mode is turned on.
• When Power Saving is On, the following settings are not available.
• When Power Saving is On, the network function is not available when the projector is in
standby mode.
Active VGA Out
Selecting On outputs a VGA signal when the COMPUTER IN 1 and COMPUTER OUT
sockets are correctly connected to devices. The projector outputs the signal received only
from COMPUTER IN 1.
Active Audio Out
Selecting On outputs an audio signal when the AUDIO IN 1 and AUDIO OUT sockets are
correctly connected to devices. The projector outputs the audio signal received only from
AUDIO IN 1.
Quick Power Off
Selecting On enables the function and the projector will not enter the cooling process after
being shut down. Selecting Off disables the function and the projector will enter normal
cooling process after being shut down.
• If you attempt to restart the projector right after it's been turned off, it may not be turned
on successfully and will rerun its cooling procedure.
• When Off is selected, the Smart Restart function will be automatically turned off.

Shutting down the projector

I
I
1. Press POWER and a confirmation message
is displayed prompting you.
If you don't respond in a few seconds, the
message will disappear.
I
I
2. Press POWER a second time.
3. Disconnect the power cord from the wall
socket if the projector will not be used in an
extended period of time.
CAUTION
• To protect the lamp, the projector will not respond to any commands during the cooling
process.
• To shorten the cooling time, you can also activate the Quick Power Off function. See
"Quick Power Off" on page 45
• Do not unplug the power cord before the projector shutdown sequence is complete.
for details.
45