Advertisement
Mounting Rails
Adjusting Mounting Rail Depth
www.NavePoint.com
The enclosure comes with reversible
horizontal mounting rails that have
threaded holes for mounting rack
equipment. The holes on one side of the
rail are threaded for M6 hardware, while the
holes on the other side are threaded for 12-
24 hardware.
Orient the rails so the hole type required is
on top. To install equipment, use the
included M6 or 12-24 hardware to secure
equipment to the rails. (See the following
page for equipment installation
instructions.)
Warning: Make sure the enclosure is
securely mounted to the wall, or in its final
position on the floor before mounting any
equipment inside. Additionally, make sure
to make all necessary adjustments to the
rails before mounting equipment inside.
(See below for Adjusting Mounting Rail
Depth.)
Do not adjust the mounting rails
unless the equipment requires a
different mounting depth.
The rails can be adjusted in 1-inch
increments to decrease the mounting
depth from the maximum mounting
depth. The maximum adjustment is 3
inches.
5
customerservice@navepoint.com
Advertisement
