Do you have a question about the RTD 215 and is the answer not in the manual?
Questions and answers
ronald Smith
February 26, 2025
I **** using a Peavey XR Head with 6 channels out to 2 200 watt speakers. How do i hooh it up to my head ?
1 comments:
Mr. Anderson
February 26, 2025
To connect a Peavey XR Head to two 200-watt speakers using the RTD 215, follow these steps:
1. Check Power Ratings and Impedance: Ensure the Peavey XR Head can handle the total impedance of the two speakers. Most powered mixers support 4Ω or 8Ω loads.
2. Connect the RTD 215 Equalizer: - Connect the main outputs of the Peavey XR Head to the RTD 215’s inputs using appropriate cables (XLR or 1/4-inch). - Connect the RTD 215’s outputs back to the Peavey XR Head’s power amp inputs or insert points, depending on your setup.
3. Speaker Connections: - Use speaker cables (not instrument cables) to connect the speaker outputs of the Peavey XR Head to the two 200-watt speakers. - If the speakers are passive, ensure they are wired in parallel or series as needed to match the amplifier’s impedance.
4. Power On and Adjust Settings: - Turn on the Peavey XR Head and the RTD 215. - Adjust the equalizer settings on the RTD 215 for optimal sound. - Gradually increase the volume and test the system.
Ensure all connections are secure and use appropriate cables to prevent damage.
Need help?
Do you have a question about the RTD 215 and is the answer not in the manual?
Questions and answers
I **** using a Peavey XR Head with 6 channels out to 2 200 watt speakers. How do i hooh it up to my head ?
To connect a Peavey XR Head to two 200-watt speakers using the RTD 215, follow these steps:
1. Check Power Ratings and Impedance: Ensure the Peavey XR Head can handle the total impedance of the two speakers. Most powered mixers support 4Ω or 8Ω loads.
2. Connect the RTD 215 Equalizer:
- Connect the main outputs of the Peavey XR Head to the RTD 215’s inputs using appropriate cables (XLR or 1/4-inch).
- Connect the RTD 215’s outputs back to the Peavey XR Head’s power amp inputs or insert points, depending on your setup.
3. Speaker Connections:
- Use speaker cables (not instrument cables) to connect the speaker outputs of the Peavey XR Head to the two 200-watt speakers.
- If the speakers are passive, ensure they are wired in parallel or series as needed to match the amplifier’s impedance.
4. Power On and Adjust Settings:
- Turn on the Peavey XR Head and the RTD 215.
- Adjust the equalizer settings on the RTD 215 for optimal sound.
- Gradually increase the volume and test the system.
Ensure all connections are secure and use appropriate cables to prevent damage.
This answer is automatically generated