Table of Contents
Advertisement
TO PREVENT INJURY TO YOURSELF or damage to the Bench Grinder, turn the switch to the
"OFF" position and unplug the power cord from the electrical receptacle before making any
adjustments.
PROBLEM
LIKELY CAUSE(S)
1. Machine not plugged in
2. Power switch in "OFF" position
Motor does
3. Power switch or cord is faulty
not run
4. Fuse or circuit breaker are open
5. Material wedged between wheel
Motor does
1. Incorrect line voltage
not have full
power
2. Motor capacitor has failed
1. Motor is overloaded
Motor runs hot
2. Poor air circulation around motor
3. Overuse in high ambient
1. Motor is overloaded
Motor stalls or
2. Incorrect line voltage
runs slow
3. Motor capacitor has failed
1. Motor is overloaded
2. Overloaded electrical circuit
Fuses blow or
3. Undersized fuse or circuit breaker
circuit breaker
4. Defective cord, plug or switch
trips
5. Undersized or excessive length of
6. Material wedged between wheel
CORRECTING EXCESSIVE WHEEL WOBBLE
The performance of your bench grinder can be improved with just a little time performing a few simple
tune-up steps. Make sure the grinder is always unplugged during any adjustment or wheel changes.
The large flange washers may not run perfectly true and can be adjusted by making a reference mark
on each flange washer and the wheel to record their original location. Next, loosen the shaft nut and
slightly rotate one flange washer clockwise and the other counterclockwise.
These movements should only be about one-half an inch at a time; then snug up the shaft nut by
hand and spin the wheel by hand. Observe any change. This rotation should minimize any
oscillation caused by flange washers. Now re-tighten the shaft nuts and dress the wheel. The center
bushings supplied by aftermarket grinding wheel manufacturers are designed to roughly center the
wheel on the shaft. The flange washers hold the wheel; dressing with a wheel dresser will make the
wheel run true.
If adjusting the flange washers does not make the wheel run without side-to-side oscillation, then
remove the wheel and flange washers and check the shoulder on the motor shaft at the point where
the flange washer seats against it. A slight burr on the edge of the shoulder can stop the flange wash-
er from seating properly. This can be removed by using a file to smooth the edge of the shoulder.
Look for any roughness on the surfaces of the flange washers and smooth these spots on sandpaper
placed on a flat surface. Then replace the wheel, re-adjust the flange washers, and dress the wheel.
Page 18
TROUBLESHOOTING
and tool rest or guard
temperature room
creating a short circuit
extension cord, see page 8
and tool rest or guard
SOLUTION(S)
1. Plug power cord into electrical receptacle
2. Lift switch to "ON" position
3. Replace switch or power cord
4. Overloaded electrical circuit
5. Turn grinder off, unplug power cord and
remove material
1. Have a qualified electrician check circuit for
proper voltage
2. Replace motor capacitor
1. Reduce pressure on work piece
2. Remove any blockage around motor
3. Reduce runtime to 20 minutes or less
1. Reduce pressure on work piece
2. Have a qualified electrician check circuit for
proper voltage
3. Replace motor capacitor
1. Reduce pressure on work piece
2. Reduce the amount of items on circuit
3. Replace with correct fuse or circuit breaker
4. Replace with new parts
5. Use correct size and length of extension cord
6. Turn grinder off, unplug power cord and
remove material
Advertisement
Table of Contents
