Advertisement
1. Product Description
This document describes the hardware installation procedures for the Allure
EC-Sensor-T (temperature only); a space temperature sensor, inside an Allure
enclosure (Figure 1-1), used to monitor room temperature.
The Allure EC-Sensor-T's modern, alluring profile enclosure is suitable for
classrooms, hotels, executive areas, office spaces and other commercial
areas. It consists only of a temperature sensor (thermistor), approximately
4.75 inches (12 cm) of wire and a clip with adhesive inside the enclosure
(Figure 1-2).
Mounting hardware with a separate sub-base is provided with the device for
installation on a dry wall or on an electrical junction box.
Figure 1-1: Allure EC-Sensor-T space temperature sensor
www.distech-controls.com
Hardware Installation Guide
Figure 1-2: Inside the Allure EC-Sensor-T enclosure - temperature sensor
(thermistor), approximately 4.75 inches (12 cm) of wire and a clip to hold
thermistor/wire in place.
Allure™ EC-Sensor-T:
Space temperature sensor
1/3
Advertisement
Table of Contents
Related Manuals for Distech Controls Allure EC-Sensor-T
Summary of Contents for Distech Controls Allure EC-Sensor-T
- Page 1 EC-Sensor-T (temperature only); a space temperature sensor, inside an Allure enclosure (Figure 1-1), used to monitor room temperature. The Allure EC-Sensor-T’s modern, alluring profile enclosure is suitable for classrooms, hotels, executive areas, office spaces and other commercial areas. It consists only of a temperature sensor (thermistor), approximately 4.75 inches (12 cm) of wire and a clip with adhesive inside the enclosure...
- Page 2 ©, Distech Controls Inc., 2013. All rights reserved. Specifications subject to change without notice. While all efforts have been made to verify the accuracy of information in this manual, Distech Controls is not responsible for damages or claims arising from the use of this manual. Persons using this manual are assumed to be trained HVAC specialist / installers and are responsible for using the correct wiring procedures and maintaining safe working conditions with fail-safe environments.
- Page 3 6. Device Dimensions Wall Mounting Installation Procedure The Allure EC-Sensor-T sensor can be mounted on a dry wall using supplied screws. 1. Remove the security screw from the device (Figure 5-1). 2. Open the device by pressing in the two (2) tabs on the bottom of the device and pulling the bottom side of the front plate out.
Need help?
Do you have a question about the Allure EC-Sensor-T and is the answer not in the manual?
Questions and answers