Gitzo GS5760D - Adapter Instructions Manual

Gitzo GS5760D - Adapter Instructions Manual

Advertisement

Gitzo GS5760D - Adapter Instructions Manual

Set up

Set up

How to remove the camera plate from the adapter

Press the safety button and rotate the locking lever as showed in figure.
Removing the camera plate from the adapter

Fix quick release adapter on the head

Screw the quick release adapter on head and, with the supplied key, tight the grub screw against the base of the head.
Fix quick release adapter on the head

How to mount the camera on the plate

To tighten the plate "A", you can use

  • a coin
    Mounting the camera on the plate - Using a coin
  • hex key "E"
    Mounting the camera on the plate - Using a hex key
  • the screw's flip ring
    Mounting the camera on the plate Using a flip ring

How to mount the camera on the adapter

Insert the camera plate into the adaptor and then press plate "A" downwards until the locking lever closes with an audible click.
warning Make sure that plate is fully locked by pushing lever (in the direction shown in fig. 6) and checking that the camera is fitted securely. Make sure that the safety button "S" is out of the locking lever. Make sure that screw "G" is fully locked, and do not adjust it after locking the plate.
Mounting the camera on the adapter - Part 1
Mounting the camera on the adapter - Part 2

Safety pin

The quick release adaptor allows the lateral sliding of the plate when the locking lever is not fully locked, and includes a safety pin that prevents accidental fallings of the camera.
About the Safety pin

Usage with other brand plates

The quick release adaptor is also designed to accommodate some plates with similar dimensions.
Test your plate by mounting it on the adaptor.
warning See how far the locking lever rotates at the time of mounting, push the lever for fully locking and check that the plate does not slide.
Fig. 8B: If the locking lever does not rotate far enough and the plate cannot be fully locked, try rotating screw "G" until it reaches the end, and then test your plate again.

Usage with other brand plates

Removing the safety pin

If you are using a non-Gitzo plate and the safety pin blocks the mounting of the plate, or prevents the lateral sliding of the plate, remove the safety pin following fig. 9.
Removing the safety pin

In addition to reading these instructions, it is also important to read the general instructions printed on the warranty card packed with your product.

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Gitzo GS5760D - Adapter Instructions Manual

Advertisement

Need Assistance?

Do you have a question about the GS5760D that isn't answered in the manual? Leave your question here.

Error while submitting your question. Please, reload page and try again.

Thank you! Your question has been received!

Table of Contents