Table of Contents
Advertisement
NOTE:
1. If the VCR is turned on with the antenna not connected, all
channels are skipped. Therefore, firmly connect the antenna and
then turn the VCR off and on again to execute Auto tuning.
2. When Auto Tuning is canceled halfway, Auto Tuning is not
execute even if the VCR is turned off and then turned on again,
In this case, Auto Tuning has to be restarted by the following
procedures.
A. Press EJECT and remove the Videocassette.
B. Keep UP and DOWN on the VCR pressed simultaneously for 3
seconds or more during the VCR on.
The channel displayed on the VCR display disappears for
moment then changes to 2.
C. Turn off the VCR and then turn it on. Auto Tuning commences.
3. If you turn the VCR off during Auto Tuning, Auto Tuning will stop
halfway.
The VCR should be reset and restarted by the item 2 in order to
execute Auto Tuning.
4. If the VCR starts playback during Auto Tuning, Auto Tuning will
stop halfway.
The VCR should be reset and restarted by the item 2 in order to
execute Auto Tuning.
5. To cancel Auto Tuning Mid-operation, press POWER During Auto
Tuning (The VCR is turned off).
6. When the VCR is moved to the other area or country, TV
broadcasts should be stored again.
2.4.2. CHECKING OF MAIN C.B.A.
When servicing the MAIN C.B.A., take out the MAIN C.B.A. and mechanism from the frame. Turn
the MAIN C.B.A. over as shown in
Fig.
S1.
Fig. S1
9
Advertisement
Table of Contents
