Table of Contents
Advertisement
Cleaning the oil discharge hole
Small dust or particles may be built up in the oil discharge
hole during operation. These dust or particles may impair the
oil to flow and cause an insufficient lubrication on the whole
saw chain. When a poor chain oil delivery occurs at the top of
guide bar, clean the oil discharge hole as follows.
1.
Remove the sprocket cover and saw chain from the tool.
2.
Remove the small dust or particles using a slotted
screwdriver or the like.
2
Fig.33
► 1. Slotted screwdriver 2. Oil discharge hole
3.
Insert the battery cartridge into the tool. Pull the
switch trigger to flow built-up dust or particles off the oil
discharge hole by discharging chain oil.
4.
Remove the battery cartridge from the tool. Reinstall the
sprocket cover and saw chain and guide bar on the tool.
Replacing the sprocket
CAUTION:
A worn sprocket will damage a new
saw chain. Have the sprocket replaced in this case.
Before fitting a new saw chain, check the condition of
the sprocket.
1
Fig.34
► 1. Sprocket 2. Areas to be worn out
Always fit a new locking ring when replacing the
sprocket.
1
Fig.35
► 1. Locking ring 2. Sprocket
NOTICE:
as shown in the figure.
Storing the tool
1.
Clean the tool before storing. Remove any chips
and sawdust from the tool after removing the sprocket
cover.
2.
After cleaning the tool, run it under no load to lubri-
cate the saw chain and guide bar.
3.
Cover the guide bar with the guide bar cover.
4.
Empty the oil tank.
2
16 ENGLISH
1
2
Make sure that the sprocket is installed
Advertisement
Table of Contents
