Toshiba RAS-18J2KVG-E Installation Manual page 5

A special tool for the R32 or R410A refrigerant is required for installation.
Thickness of copper pipes used R32 must be more than 0.8 mm. Never use
copper pipes thinner than 0.8 mm.
After completion of installation or service, con
refrigerant gas. It may generate toxic gas when the refrigerant contacts with fi re.
When the indoor unit is connected with multi-split R32 outdoor unit 3M26, 4M27
and 5M34.
Please see IMS outdoor unit installation manual and consult your dealer about
the minimum foor area.
Comply with national gas regulations.
CAUTION
Exposure of unit to water or other moisture before installation could result in
electric shock.
Do not store it in a wet basement or expose to rain or water.
After unpacking the unit, examine it carefully for possible damage.
Do not install the unit at place where leakage of fl ammable gas may occur. In
case gas leaks and accumulates at surrounding of the unit, it may cause of fi re.
Do not install in a place that can increase the vibration of the unit. Do not
install in a place that can amplify the noise level of the unit or where noise and
discharged air might disturb neighbors.
To avoid personal injury, be careful when handling parts with sharp edges.
Please read this installation manual carefully before installing the unit. It contains
further important instructions for proper installation.
The manufacturer shall not assume any liability for the damage caused by not
observing the description of this manual.
REQUIREMENT OF REPORT TO THE LOCAL POWER SUPPLIER
Please make absolutely sure that the installation of this appliance is reported to
the local power supplier before installation. If you experience any problems or if the
installation is not accepted by the supplier, the service agency will take adequate
countermeasures.
Important information regarding the refrigerant used
This product contains fl uorinated greenhouse gases.
Do not vent gases into the atmosphere.
Refrigerant type: R32
GWP value: 675 * (ex. R32 ref. AR4)
(1)
GWP = global warming potential
(1)
The refrigerant quantity is indicated on the unit name plate.
* This value is based on F gas regulation 517/2014
fi rm there is no leakage of
3
EN
ES
FR
IT
DE
PT
PL
CZ
RU
CR
HU
NL
GR
SV
FI
NO
DA
RO
BG
EE
LV
SK
SI
LT