Advertisement
Let Vekooto be your eyes! ---VEKOOTO
3. The wiring method when product use, as follows:
(1) Connect Yellow wire to positive power(12-35V).
(2) Connect Red wire to ACC.
The red wire is connected to the car ignition wire ACC switch
(which is the gear switch before starting up the car's motor),
when the car key is turned on, the device will start automatically,
and if the vehicle key is turned off, it will automatically turn off.
(3) Connect Black wire to negative power / Ground / Sheet Metal
(4) Connect Blue wire (CH2 trigger) to reversing light.
4. The wiring method when product test, as follows:
(1) Connect Yellow wire and red wire together to the positive power
(12-35V).
(2) Connect Black wire to Ground.
(3) Ignore Blue color trigger wires.
* Before installing it by professional person, please test it if works well,
like image display, just in case and save your precious time. Please
contact us if you have any question anytime, our email is
Vekooto@outlook.com
Note:
1) Before connecting, you need to confirm that the voltage of the battery
is between 12 - 35V.
2) After connecting the wires, pay attention to the insulation between
the power cables to prevent.
the power cables from short-circuiting the battery.
3) The yellow wire must be connected to the ignition wire, otherwise the
device will not support the ignition switch.
4) When you install the 4pin cable,please target every pin to the hole,
avoid breaking the pin.
5
Advertisement
