BEA 10COMBOPLATE Manual

Visit website for available
languages of this document.
TECHNICAL SPECIFICATIONS
Key switch:
Push plate:
Dimensions:
‰ Shut off all power going to header before attempting any wiring procedures.
!
‰ Maintain a clean and safe environment when working in public areas.
‰ Constantly be aware of pedestrian traffic around the door area.
‰ Always stop pedestrian traffic through the doorway when performing tests that may result in unexpected reactions by the door.
‰ ESD (electrostatic discharge): Circuit boards are vulnerable to damage by electrostatic discharge. Before handling any board,
ensure you dissipate your body's ESD charge.
CAUTION
‰ Always check placement of all wiring before powering up to ensure that moving door parts will not catch any wires and cause
damage to equipment.
‰ Ensure compliance with all applicable safety standards (i.e. ANSI A156.10) upon completion of installation.
‰ DO NOT attempt any internal repair of the components. All repairs and/or component replacements must be performed by BEA,
Inc. Unauthorized disassembly or repair:
1. May jeopardize personal safety and may expose one to the risk of electrical shock.
2. May adversely affect the safe and reliable performance of the product resulting in a voided warranty.
PRE-INSTALLATION CHECK
1. When preparing to wire multiple devices together for a 'system' configuration, it is best to ensure the
correct operation of each device independently before starting to help reduce troubleshooting time
later in the event of a discrepancy.
2. Prior to installing any equipment, ensure the correct line voltage and stability. When applying equipment
on a new installation utilizing new electrical supply circuits, always ensure that correct line voltage
exists and is stable. Remember to shut the power back off after this is checked and before performing
any wiring to the system.
©BEA | Original Instructions
75.5645.05 COMBO PLATE 20230413
SPST / Maintained (10COMBOPLATE) or Momentary contact (10COMBOPLATEMOM)
Cherry switch − SPST / Momentary Contact: 15A @ 125 VAC
4 1/2" × 4 1/2"
Combination keyswitch and Push Plate switch
Specifications are subject to change without prior notice.
All values measured in specific conditions.
COMBO PLATE
Page 1 of 2