Advertisement
INSTALLATION
1. Install a double-gang electrical box.
2. Assemble the keyswitch portion of the assembly with a mortise cylinder
(not included) − Figure 1.
3. NOTE: BEA recommends that a 1
this assembly; however, a 1
Select the appropriate cam depending on the switch configuration
(Figure 2).
4. Wire the Combo Plate for its intended use. The keyswitch can be
wired to toggle the push plate switch ON and OFF (Figure 3) or the two
switches can be wired for independent use.
5. Partially insert the two socket-cap screws into the upper-left and lower-
left mounting holes of the electrical box. Slide the key holes of the
Combo Plate over the screws and tighten by inserting a hex wrench into
the through-holes of the push plate. Fasten the right side of the Combo
Plate using two flathead screws (Figure 4).
6. NOTE: The installer may choose between two styles of screws: Phillips-
head screws or tamper-resistant spanner screws (both provided in the
hardware kit).
N.C. - RED
COM. - BLACK
N.O. - GREEN (10COMBOPLATE)
N.O. - WHITE (10COMBOPLATEMOM)
BEA, INC. INSTALLATION/SERVICE COMPLIANCE EXPECTATIONS
BEA Inc., the sensor manufacturer, cannot be held responsible for incorrect installations or incorrect adjustments of the sensor/device; therefore, BEA Inc.
does not guarantee any use of the sensor/device outside its intended purpose.
BEA Inc. strongly recommends that installation and service technicians be AAADM-certifi ed for pedestrian doors, IDA-certifi ed for doors/gates, and
factory-trained for the type of door/gate system.
Installers and service personnel are responsible for executing a risk assessment following each installation/service performed, ensuring that the sensor/
device system performance is compliant with local, national, and international regulations, codes, and standards.
Once installation or service work is complete, a safety inspection of the system shall be performed and documented per the manufacturer's
recommendations or industry guidelines. Examples of compliance may apply to ANSI 156.10, ANSI 156.19, ANSI/DASMA 102, ANSI/DASMA 107,
UL294, UL325, and International Building Code.
Tech Support & Customer Service: 1-800-523-2462 | General Tech Questions: techservices-us@BEAsensors.com | Tech Docs: www.BEAsensors.com
©BEA
| Original Instructions
75.5645.05 COMBO PLATE 20230413
⁄
" length mortise cylinder be used in
1
8
⁄
" length mortise cylinder will also work.
1
4
Figure 3
DOOR
CONTROL
STALL COM
COM
COM
STALL
SAFETY
N.O.
N.C.
ACTIVATION
Mortise
Cylinder
Wall Plate
A
Adjust height of switch on bracket until
cam triggers positively when rotated.
Figure 4
6-32 Flathead
Screws (2)
Figure 1
Switch
Cylinder
Bracket
Lock
Figure 2
B
6-32 Socket-Cap
Screws (2)
Page 2 of 2
Advertisement
