Samsung P843GW/YLP Service Manual page 9

Table of Contents

Advertisement

5. Main function
9) Fuzzy washing function (weight-sensing)
☞ After finishing initial water supply, when the fall of the water level needs supplementary water supply,
Sensing function perceives the weight with the supplementary water supply numbers and starts to work.
Under the course of Cotton, or Coloureds, if the supplementary water supply numbers become 3 - 4 times the
function is going at default condition ( high water level ), if 1-2 below that is going at middle level, if 0 below
low water level, heating hours and rinse hours depend on the above data.
ECO PRE mode is selected, the process going on at default condition.
High
Middle
Low
※ After sensing weight, above hours is decreased from above default hours
10) Bubble -detecting function
At the each condition of washing&dehydrating , rinse&dehydrating , hydrating, bubble-detecting function works,
this function works 5times normally, if the function detects bubbles at 6 times , the bubble-detecting function
stops and go on to the next process.
● The bubble-detecting function during washing & dehydrating to rinse & dehydrating
after 2 times instant dehydrating and before main dehydrating, if the water level is under 25.50 KHZ, Bubble
→ Detecting function thinks there are bubbles and add the bubbles-removing rinse, needing hours are above
hours and 8 min 40 sec.
→ The bubble-detecting function during single hydrating process
after 2 times instant dehydrating and before main dehydrating , if the water level is 25.50 KHZ below or
during main dehydrating, water level data is 24.30 KHZ below Bubble-detecting function thinks there are
bubbles and add the bubbles-removing rinse 1 times, needing hours are above hours and 5 min 55 sec.
Bubble-detecting function operating process
laundry scattering
draining &reverse
1 min
Washing hours
Cotton
Default
Default-12 min
Default-25 min
20 sec
unbalance
detecting range
Coloureds
Default
Default-7min
Default-15min
600rpm
500rpm
bubble detection
(default water level 25.50 KHZ below)
8
Rinse water level
Default
22.80 KHZ
24.10 KHZ

Advertisement

Table of Contents
loading

Table of Contents