Table of Contents
Advertisement
TO INSTALL ANTI-TIP BRACKET
1
Using the template provided with the Anti-Tip Bracket, locate
the installation area of the Anti-Tip Bracket. The Anti-Tip
Bracket may be installed at either the back-left or back-right
corner of the installation space, and only one Anti-Tip Bracket
is necessary.
2
Mark the location of the screws for the Anti-Tip Bracket.
3
Attach the Anti-Tip Bracket to the floor or wall.
Wood Construction Installation: Drill a
screws are to be located. If bracket is to be mounted to the wall,
drill pilot hole at an approximate 20° downward angle. Screw must
enter wood.
Masonry Construction Installation: Due to the variety of masonry
materials that may be present at installation site, hardware is not
provided for attaching the Anti-Tip Bracket to masonry. If the
bracket is to be mounted to masonry or ceramic floors, attach using
two
5
/
" OD sleeve anchors (with
16
hex nut head) rated for minimum 300 lb tension for the masonry
material present at installation site.
REAR TRIM KIT INSTALLATION
(OPTIONAL)
If there is no counter surface around the back edge of the installa-
tion space, or if the countertop cutout is greater than 25" deep, this
may prevent the range from being installed flush to the back wall.
If this occurs, a trim kit can be installed to cover a gap up to 1" in
width. See Figure 4.
SLIDE-IN INSTALLATION
COUNTER CONTINUES BEHIND
CUTOUT SPACE, AND NO REAR
FILLER TRIM IS REQUIRED.
1
/
" pilot hole where
8
1
/
" bolt, either hex bolt head or
4
FREESTANDING INSTALLATION
NO COUNTER BACK-SPLASH
IS LEFT; REAR FILLER TRIM IS
RECOMMENDED.
FIGURE 4
TO INSTALL REAR TRIM
1
Align filler trim to mounting holes.
2
Attach with screws provided as shown in Figure 5.
ELECTRICAL SUPPLY CONNECTION
WARNING
ELECTRICAL SHOCK HAZARD
• Installation must be electrically
grounded in accordance with local
codes or, in the absence of local
codes, with the National Electrical
Code, NFPA 70.
• Do not use an extension cord with
this product.
• The power supply cord and plug should not be modified. If it
will not fit the outlet, have a proper outlet installed by a qualified
electrician.
• Remove the house fuse or open the circuit breaker before begin-
ning installation.
• Effective January 1, 1996, the National Electrical Code requires
that new construction (not existing) utilize a 4-conductor con-
nection to an electric range.
• The appliance must be properly installed and grounded by a
qualified service provider.
This appliance must be supplied with the proper voltage and fre-
quency and be connected to an individual, properly grounded branch
circuit protected by a circuit breaker or fuse having amperage as
specified on the rating plate. The rating plate is located above the
drawer on the oven frame. After installation, instruct the consumer
where the main range electrical disconnect is located and how to
operate it.
5
FIGURE 5
Advertisement
Table of Contents
