Table of Contents
Advertisement
9.3 AutoDose basic setting
The factory pre-set doses for a large
load are 90 ml for detergent tank and
25 ml for fabric softener tank: the
optimal configuration to meet majority
of use condition. The appliance will
use these settings to calculate the
precise dosage for each wash based
on load size.
However, under extreme conditions (very
soft or very hard water) and particular
type of detergent (such as super
compact), we recommend to adjust the
pre-set dosage by following the
indication given on detergent and fabric
softener container: e.g when using super
compact detergent you may need to
reduce the pre-set dosage considerably.
If the washing results are not satisfying
or there is too much foam during
washing, you may need to change the
factory setting. Read in the paragraph
'AutoDose configuration mode' how to
change the basic setting, but before:
Water hardness levels
Levels
Water hardness range
Soft
4)
15 - 25
Medium
Hard
1) French degrees
2) German degrees
3) English degrees
4) Factory setting, able to satisfy most of the use conditions.
9.4 AutoDose configuration
mode
Enter the AutoDose
configuration mode before
proceeding with any
programme setting. The
configuration mode may
cancel temporary settings .
1. Press the On/Off button for a few
seconds to activate the appliance.
1)
2)
°f
°d
<15
<8
8 - 14
>25
>14
1. Identify the water hardness level.
Check the water hardness level in
your area. The levels are generally
indicated as: soft, medium and hard.
If necessary, please contact your
local water authority to check the
water hardness in your area.
2. Identify the customized detergent
dosage.
Check the label in the detergent/
fabric softener container and identify
the quantity to use. The suggested
quantity is the combination of three
different factors:
• Water hardness level (see the
following table);
• Normal soil level;
• Rated capacity of the appliance
(e.g. maximum load capacity 9
kg). If the rated capacity on the
product container refers to lower
capacity appliances, the
customized dosage should be
increased.
mmol/l
3)
°e
<10
<1.4
0 - 17
1.5 - 2.5
>17
>2.5
2. Wait about 10 seconds for appliance
internal check.
3. To enter in configuration mode, hold
pressed the Temp. °C and the
Centrif. buttons simultaneously for a
few seconds until the display shows
the
on the left in the display
and blinking detergent tank
softener tank
right in the display.
ENGLISH
23
ppm
<140
150 - 250
>250
and
indicators on the
Advertisement
Table of Contents
