Electrical Connection; General Information - BORETTI MLIQX604 Instruction Manual

3.1 Electrical connection

Electrical voltage
Danger of electrocution
• Have the electrical connection carried out by qualified technical personnel.
• The earth connection is obligatory according to the methods foreseen by the
safety regulations of the electrical system.
• Turn off the general power supply.
• The installation and connection of the appliance can only be carried out by a
qualified electrician. Contact an electrician who is knowledgeable of the local
rules and additional regulations issued by the local electricity operator and ensure
that the work is carried out in compliance with the same. The manufacturer is
not responsible for damage caused by incorrect installation or connection of the
appliance. To prevent damage to the appliance, recess it only after installing the
units and the extractor hood.
• The electrical safety of the appliance is only guaranteed if it is connected to a
compliant earthing conductor. It is very important to verify that this condition is
fulfilled as it is a fundamental premise. If in doubt, have the system checked by a
specialist technician. The manufacturer is not responsible for damage caused by the
absence or interruption of the earthing conductor.
• Pay attention (conformity) to phase and neural allocation of house connection
and appliance (connection schemes); otherwise, components can be damaged.
Warranty does not cover damage resulting from improper installation

3.2 General Information

• Check that the characteristics of the electrical network are suitable for the data
shown on the plate.
• The identification plate, with technical data, serial number and marking is visibly
positioned on the appliance.
• The appliance works with 220-240V or 380-415V, based of type connection.
• Provide for the earth connection with a cable longer than the others by at least
20mm.
• The necessary connection data is indicated on the plate and must correspond to
that of the mains.
• Determine the various connection possibilities from the diagram from the next
page and in according to table1.
INSTALLATION
9