Table of Contents
Advertisement
Activating the memory function
Figure 4-2: Activating the memory function
All drive positions up to their stop position
If the eSlider control unit is being used for the first time, make sure to
carry out the steps below.
The same applies after disconnecting the supply voltage:
1
Move the eSlider's linear unit by hand to its front position until the power off
function is activated and the eSlider stops automatically
2
Move the eSlider's swivel unit by hand to the drive position until the power off
function is activated and the eSlider stops automatically
Move the eSlider's lift unit by hand to its lowest position until the power off
3
function is activated and the console stops automatically
Operation
4-3
Advertisement
Table of Contents
