Advertisement
5. Install the glass panel onto the glass clamp of each post and
base plate assembly.
a. Remove the machine screw that secures the top plate of
each glass clamp. Remove the top plate and nylon washer
from each clamp.
b. Position the glass panel on top of the glass clamp, making
sure the edge brace on each clamp is against the side of the
glass.
NOTE: Always position nylon washers with the raised lip facing the
glass.
c. Place the nylon washer followed by the top plate onto the
glass panel aligned with each glass clamp, and secure in
position using the machine screw. Tighten the screw until it
holds the glass securely—do not over-tighten.
Machine Screw
Glass Clamp
Edge
Brace
NOTE: Always loosen the thumb screws/hex cap screws on the
glass clamps before attempting to the adjust the angle of
the glass panel. Failure to loosen the screws will strip the
internal grip fittings.
Machine
Screw
Top Plate
Nylon
Washer
Glass Panel
installed onto
Post and Base
Plate Assembly
HATCO CORPORATION
P.O. Box 340500
Milwaukee, WI 53234-0500 U.S.A.
414-671-6350
support@hatcocorp.com
www.hatcocorp.com
6. Adjust the angle of the glass panel, if necessary. NOTICE: Two
people are required for this step.
• The angle of the glass panel can be adjusted in 15°
increments.
• Simultaneously loosen the thumb screw/hex cap screw on
each glass clamp, carefully rotate the glass panel to the
desired position, and re-tighten the thumb screws/hex cap
screw.
Shield
removed
for clarity.
Hex Cap
Screw
7. Adjust the height of the glass panel, if necessary. This step will
require two people.
a. On each post, loosen the safety set screw on the twist-lock
nut, and turn the twist-lock nut counterclockwise to loosen.
b. Carefully move the glass panel to the desired height.
c. On each post, turn the twist-lock nut clockwise to secure its
position, and tighten the safety set screw on the twist-lock
nut.
Twist-Lock
Nut
Safety Set
Screw
Cleaning/Maintenance
Clean the unit daily using non-abrasive cloths and cleaners.
• The glass panel can be cleaned using a standard glass cleaner.
Options and Accessories
End Panels
End Panels with a depth of 18" (457 mm) are available for all
B-950P portable sneeze guards.
LED Light Bar
An LED light bar is available as a factory-installed option for certain
sizes and can be configured with a cord and plug or a battery pack.
2
Move shield
to desired
angle.
Shield
removed
for clarity.
Move both
extendable
posts to desired
height.
© 2022 Hatco Corporation
Advertisement
